Clifford Blackjax doesn’t accept PIN

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86839
Printed Date: May 14, 2025 at 1:35 AM

Topic: Clifford Blackjax doesn’t accept PIN

Posted By: rwat
Subject: Clifford Blackjax doesn’t accept PIN
Date Posted: December 08, 2006 at 7:17 AM

Blackjax activated and shut the car down while my wife attempted to drive out of a parking lot . Switch did not accept the PIN, so the car was shut down.
Towed the car home, tested switch, found it to be defective and replaced it.

Now unable to turn off the led and reset system. Red led continues to flash all of the time even though I input the correct PIN. Switch tests OK.
Before this incident , the system worked fine.
Any suggestions?

Replies:

Posted By: mauri197
Date Posted: December 08, 2006 at 9:11 AM

did you try resseting the system by disconnecting the battery for a couple of minutes i then puting the code in with the ignition on

Posted By: rwat
Date Posted: December 08, 2006 at 11:10 PM

I took both fuses out , but apparently did not wait long enough. Did so for a few minutes based on your response, and the system now works fine.

Thanks mauri197 ,for your help.

Print Page | Close Window