Qustion About remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=8694
Printed Date: May 17, 2024 at 7:53 PM

Topic: Qustion About remote start

Posted By: h0twh3els
Subject: Qustion About remote start
Date Posted: January 27, 2003 at 11:35 PM

Hi,

I had to replace a control module in my truck for the remote start/alarm. the only problem is, my truck starts, then turns off a second later. it will not stay running. i've checked the hood pin switch, the brake pedal etc, and im stumped. my truck is a 99 gmc sonoma. any suggestions would be great. thanks-

Replies:

Posted By: Too Dark
Date Posted: January 28, 2003 at 12:02 AM

did you bypass the pasloc security system?

Posted By: ViperATC5
Date Posted: January 28, 2003 at 5:19 PM

when you replaced the control module with the new one it seems that you did not reprogram the new one to learn the tach signal on the vehicle - reprogram the unit to your tach signal and you should be allset

Also, you need to program the resistance code to the 555L bypass module, unplug the control unit completely again - to erase any memory in the L, then plug it back in. Before attempting to remote start the truck, start it with the key and let it run for 5 seconds - the 555L will learn the proper resistance code needed for remote start. Program the tach setting on the unit, and you should be good to go