autopage rs 620 starter in 01 caravan

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=86976
Printed Date: May 02, 2025 at 6:17 PM

Topic: autopage rs 620 starter in 01 caravan

Posted By: desbolib
Subject: autopage rs 620 starter in 01 caravan
Date Posted: December 10, 2006 at 5:10 PM

Been pulling my hair out for hours and have found out what I need to know but now I need to know how to do it the problems that I am having is wiring the locks and the second ignition . This starter comes with a starter out that goes to ground on the crank so do I just need the 180 resistor in line without a relay?also can I do the same with the locks or not?I have done some research and have found different opinions and any help would be appreciated thanks. (ps if I do need relays diagrams would be great ) thanks

Replies:

Posted By: Velocity Motors
Date Posted: December 10, 2006 at 7:44 PM

It all depends on your remote starter system. I use the Compustar systems and I don't use a relay for the door locks or the 2nd starter output. You will need to test this for the system your installing by first not using relays nd if it works, time after time, then your good to go. I have not had any problems with any of the customer's vehicles not starting because it didn't trigger the 2nd starter wire from the Compustar unit.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: desbolib
Date Posted: December 11, 2006 at 6:46 PM

thanks for the prompt response . On this unit I think that I need relays but still not sure how to wire them in thanks again

Posted By: Mike M2
Date Posted: December 11, 2006 at 7:09 PM

Ok, the starter relay wires like this, 86 to 12volts, 85 to the RS ground out during crank, 87 to the PURPLE / brown starter wire, 30 to ground thru a 180ohm resistor.

posted_image

For locks, wire two relays like this, 86 to 12volts, one 85 to the lock and one 85 to the unlock

outputs on your alarm, 30 to ground, On the lock relay, add a 5.3k resistor to 87, and on the

unlock relay add a 2.0k resistor to 87. Tie the two resistors together at the end away from the relay and

connect to

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: desbolib
Date Posted: December 12, 2006 at 5:22 PM

thanks thats what I needed to know will let you know when it works thanks again