2006 Mazda 6, clifford 50.5x

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87032
Printed Date: May 11, 2025 at 4:08 PM

Topic: 2006 Mazda 6, clifford 50.5x

Posted By: 05gt
Subject: 2006 Mazda 6, clifford 50.5x
Date Posted: December 11, 2006 at 3:03 PM

I am wondering if someone has done doorlocks on one of these, I have tried for about a day now with no such luck

this vehicle is the one with the smart/intelligent key and has the full factory alarm

I have checked about 5 sites that say different things, This is what I have BLUE in the driver kick panel is arm/disarm with resistors and blah blah blah, does this wire also lock the doors or does it strictly do factory arm/disarm

any help will be appreciated

thanks in advance Mike

Replies:

Posted By: cibo55
Date Posted: December 11, 2006 at 9:35 PM

FUNCTION	DATACOLOR	LOCATION	POLARITY
+12 VOLTS	BLACK	IGNITION HARNESS	+
+12 VOLTS	BLACK / YELLOW	IGNITION HARNESS	+
IGNITION	BLUE	IGNITION HARNESS	+
ACCESSORY	BLACK/ RED	IGNITION HARNESS	+
ACCESSORY 2	BLACK/ WHITE	IGNITION HARNESS	+
Comments: Optional, powers radio.
STARTER	BLACK/ BLUE	IGNITION HARNESS	+
KEY SENSE	WHITE/ BLUE	AT SWITCH	+
Comments: Key sense with ignition and transponder will disarm OEM alarm.
TACHOMETER	ODD WIRE AT COILS	COIL	AC
PARKING LIGHTS	RED / WHITE	AT SWITCH	-
BRAKESWITCH	GREEN/ YELLOW	DRIVER'S KICK PANEL	+
PARKING BRAKE	BROWN	INSTRUMENT CLUSTER	-
Comments: Wire found in the instrument cluster harness on the left side of the steering column.
LOCK	LIGHT GREEN	HARNESS COMING FROM DRIVER'S DOOR	MULTIPLEX
Comments: Use a 1000 ohms resistor with a relay or a 750 ohms resistor without a relay.
UNLOCK	LIGHT GREEN	HARNESS COMING FROM DRIVER'S DOOR	MULTIPLEX
Comments: Ground only
TRUNK RELEASE	YELLOW	AT SWITCH	-
ARM	BLUE	HARNESS COMING FROM DRIVER'S DOOR	MULTIPLEX
Comments: Use a 1000 ohms resistor with a relay or a 750 ohms resistor without a relay.
DISARM	BLUE	HARNESS COMING FROM DRIVER'S DOOR	MULTIPLEX
Comments: Ground only
HORN	PURPLE / WHITE	AT SWITCH	-
LEFT FRONT DOORPIN	LIGHT GREEN/ BLACK	DRIVER'S KICK PANEL	-
RIGHT FRONT DOORPIN	RED / BLUE	DRIVER'S KICK PANEL	-
REAR DOORS	GREEN/ ORANGE	DRIVER'S KICK PANEL	-
TRUNK PIN	BROWN	DRIVER'S KICK PANEL	-
TRANSPONDER GROUND	BLACK/ BLUE	TRANSPONDER MODULE	-
TRANSPONDER IGNITION	BLACK/ WHITE	TRANSPONDER MODULE	+
TRANSPONDER RX	ORANGE / BLUE	TRANSPONDER MODULE	DATA SIGNAL
TRANSPONDER TX	GREEN	TRANSPONDER MODULE	DATA SIGNAL

i hope this will help

Posted By: KarTuneMan
Date Posted: December 11, 2006 at 10:13 PM

After reading on the Astrochart, the blue wire you mentioned in your post controls lock functions of ONLY the drivers door.

The light green that is listed above controls ALL the doors and the security.

-------------

Posted By: 05gt
Date Posted: December 11, 2006 at 10:21 PM

I should of mentioned I have the 2006 mazdaspeed 6

i have actually figured it out and it was different than what you said KarTuneMan and cibo55

the wire is blue/white in the driver kick panel, it is in a white 24 pin plug that is part of the harness coming out of the door

this wire controls factory arm/disarm, as well as lock/unlock, it also controls domelight, it is straight negative trigger through a relay and for lock it is negative through a 1000 ohm resistor and a relay

i think the wiring for the factory alarm and locks is a bit different in the 2006 mazda 6 than the 2006 mazdaspeed 6

Posted By: 05gt
Date Posted: December 13, 2006 at 11:34 AM

Anyone have any information on this vehicle to turn on the heated seats with the clifford 50.5x

Thanks in advance

Posted By: 05gt
Date Posted: December 13, 2006 at 4:11 PM

anyone??