Print Page | Close Window

2000 Accord, factory alarm disarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87142
Printed Date: May 15, 2024 at 1:47 PM


Topic: 2000 Accord, factory alarm disarm

Posted By: cpugh
Subject: 2000 Accord, factory alarm disarm
Date Posted: December 13, 2006 at 2:20 PM

I need help finding hte wire that is the factory alarm disarm.  I have looked at the wire diagram that is listed on this site and all it says is w/locks.  Can someone tell me what this means?

Thanks



-------------
CP



Replies:

Posted By: kaezoo
Date Posted: December 13, 2006 at 2:39 PM
It means that that the factory alarm disarms when the key is turned in the door, and that this action also unlocks all the doors. The diagram simply uses the wires that monitor the door key switch to do all the locking and unlocking functions as well, so whenever the aftermarket system unlocks the doors it also disarms the alarm.




Posted By: KarTuneMan
Date Posted: December 13, 2006 at 4:12 PM
FACTORY ARM Arms with lock wire    - 
 Use these wires for vehicles with factory alarm only. They are found in the green connector at the top of the passenger side fusebox. Disarm without unlock is BLUE inside driver's door. For Accord LX with no factory alarm, use BLACK/ WHITE(lock) and GREEN/ RED(unlock) found on a two pin plug at the front of the driver's side fusepanel.
 FACTORY DISARM Disarms with unlock wire    - 
 Use these wires for vehicles with factory alarm only. They are found in the green connector at the top of the passenger side fusebox. Disarm without unlock is BLUE inside driver's door. For Accord LX with no factory alarm, use BLACK/ WHITE(lock) and GREEN/ RED(unlock) found on a two pin plug at the front of the driver's side fusepanel.


-------------




Posted By: chris354
Date Posted: December 13, 2006 at 10:57 PM
If its a lx it will only arm and disarm with factory remotes. If its an ex it will arm and disarm with lock and unlock. If you are wanting to disarm without unlocking doors, on the ex its a blue wire in the drivers door at the power window switch, If its a lx the wire is at the factory keyless/alarm module attached to the drivers underside dash panel.





Print Page | Close Window