Print Page | Close Window

autostart in 02 acura el1.7

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87259
Printed Date: May 17, 2025 at 1:15 AM


Topic: autostart in 02 acura el1.7

Posted By: ervie
Subject: autostart in 02 acura el1.7
Date Posted: December 15, 2006 at 6:28 PM

hi everyone put this unit in and had tons of issues with the trunk. i used a relay and could get it to open but only sometimes

but could not get it to close. also sometime when i pushed the trunk button the car would start and the starter would stay ingaged.

so was the relay hooked up wrong or what did i do wrong.

tnx in advance




Replies:

Posted By: au5599
Date Posted: December 15, 2006 at 6:47 PM

what model autostart? how did you wire the relay? check remote start fuses to make sure they are good.

Does the system work good without the trunk hooked up?



-------------
Street Dreams Car Club
93 GRAND CARAVAN SE / Astro
Team New York SS3-4 06 & SM3-4 07 DB Drag World Finals
2003 Chevy Suburban LT / 98 GTP




Posted By: ervie
Date Posted: December 15, 2006 at 6:58 PM

used a as1735 as for the relay dont no too much about them but here goes

there were 2 power sorces the trunk wire from the remote and the yellow green from the car was cut into and each put on the relay

so before u laugh at me i did not hook this up 1 of the guys at the shop did cause i no nothing about relays





Posted By: dre187
Date Posted: December 15, 2006 at 8:00 PM

"there were 2 power sorces the trunk wire from the remote and the yellow green from the car was cut into and each put on the relay"

the trunk release wire should be positive, so no need to cut the wire. the relay should be wired like this...

85- negative trunk release from remote start   ,  86- +12v constant,  30- +12v constant,   87a- N/A,              87- tap into YELLOW /GREEN (vehicle trunk release wire)

As for the vehicle remote starting when you press the trunk button, try removing the harness that has the trunk release wire ( i believe its a 12pin harness). if the vehicle still starts while hitting the trunk release button, then you can safely assume there is either a problem with the remote configuration, or the unit itself.

try and use at least periods in your posts, its hard to break down what your asking.





Posted By: ervie
Date Posted: December 15, 2006 at 8:07 PM
sorry about the punctuation, thanks for the advice i will try that.





Print Page | Close Window