Print Page | Close Window

key resistor on 95 el dorado

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87406
Printed Date: May 10, 2025 at 12:38 PM


Topic: key resistor on 95 el dorado

Posted By: german30
Subject: key resistor on 95 el dorado
Date Posted: December 18, 2006 at 12:46 PM

I'm doing an alarm/remote start (Clifford RSX 3.2) on a 1995 Caddilac El Dorado, I was told that a resistor needs to be put for tha key in order for tha remote start to work, I never done a resistor for the key and any information or diagrams would be very helpful. Also, i would like to kno if a relay is needed for the door lock and unlock. Thanks in advance




Replies:

Posted By: jaurora
Date Posted: December 18, 2006 at 1:48 PM
Do a search for Passlock on the site. there should be more than enough info on that as this was the first stages of antitheft taken by GM

-------------
MECP certified (If it really means anything)
Jeremy



Posted By: Twelvoltz
Date Posted: December 18, 2006 at 2:59 PM
jaurora...the 95 Eldorado is VATS, not passlock


german30 do a search for VATS bypass, you will find all the information you need in these forums.

As far as the relays go, you probably do not need them. The way I have always tested a trigger to see if it needs a relay is once I have found a wire with my DMM then use an old fashioned bulb test light. I tap the bulbed test light to the wire in question, if it operates the device I do not use a relay, if it does not operate it I use a relay.


Print Page | Close Window