06 bmw z-4 locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87499
Printed Date: June 09, 2024 at 3:16 PM

Topic: 06 bmw z-4 locks

Posted By: txaggiemp
Subject: 06 bmw z-4 locks
Date Posted: December 19, 2006 at 4:22 PM

anybody install keyless on a 06 z-4? we have the remote start working but no-go on the locks. i have the directech sheet but that hasen't helped at all. i'm looking for first hand knowledge here, i've been through it with directed and they are no help.

-------------
the customer is not always right

Replies:

Posted By: KarTuneMan
Date Posted: December 20, 2006 at 12:27 AM

LOCK

Blue/red

At General module behind glovebox

In center plug

UNLOCK

White

At General module behind glovebox

In center plug

How could this be difficult? Is the module NOT there? Can you not find the wires this color? Do they NOT test properly?

-------------

Posted By: jihadmatar
Date Posted: February 17, 2007 at 2:00 PM

hello, this is jay and i install alarms and starters(basic mecp).

u seem that you know your stuff. i am working on a 1999 a4 2.8 quattro.

have a problem w door locks parts. i am installing the xs- 900s systems. according to its wiring diagarm i need to cut the main wire that is going form the vacuum pump in the trunk to the door switch. this wire should show 12v with door unlocked and 0 when locked. do you know what color or location? or am i wrong all together. any help is greatly appreciated.

email address is jihadmatar@yahoo.com

thanks.

Posted By: howie ll
Date Posted: February 20, 2007 at 4:57 PM

NO NO NO Check plugs in driver or passenger footwell look for plug on looms coming out of dor into plug, its low current neg for lock and unlock and hold the lockwiire for window close. THAT SIMPLE!

Posted By: jihadmatar
Date Posted: February 20, 2007 at 5:09 PM

howie ii,

thanks for the help. what did you mean at the end though by: hold the lock wire for window close. what does this means.

thanks again,

jay.

Posted By: howie ll
Date Posted: February 21, 2007 at 3:47 AM

Use a timed (about 5 secs) neg output and join to lock wire, see installation manual for that alarm.