Print Page | Close Window

791 module? remote start, 98 Beetle

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87597
Printed Date: May 03, 2024 at 11:51 AM


Topic: 791 module? remote start, 98 Beetle

Posted By: bug_n_67
Subject: 791 module? remote start, 98 Beetle
Date Posted: December 21, 2006 at 6:06 PM

I had the question about installing a remote starter in a 98 Beetle,and was informed it was an easy install.The question I have now has to do with the paper work I seen on the wiring guide for the car.It states I need a 791 Module and a extra key.So what is a 791 module and where do I get one and do I need it or is the info wrong.It states that I need an extra key as well,does that have to do with the chip in it.Help

Thanks

John




Replies:

Posted By: Twelvoltz
Date Posted: December 21, 2006 at 8:49 PM
According to DEI the 98 Beetle does not require a transponder bypass module. But the 99 does.



DIRECTWIRE™ WIRING INFORMATION - VOLKSWAGEN / BEETLE / 1998 / Remote Start

[PRINT THIS PAGE]

12volts      red       +       ignition harness
Starter      RED / black       +       ignition harness
Second Starter                 
Ignition      black       +       ignition harness
Second Ignition                 
Third Ignition                 
Accessory      BLACK/ red       +       ignition harness
Second Accessory                 
Keysense                 
Power Lock      yellow/lt.blue       -       inside drivers door
Power Unlock      WHITE/ green       -       inside drivers door
Notes: Requires double pulse.
Lock Motor      blue / YELLOW             inside drivers door
Unlock Motor      purple / YELLOW             inside drivers door
Parking Lights+      gray/purple             headlight switch, pin 6
Notes: There are three gray/purple wires at the headlight switch, be sure to use the one that is in pin 6 to keep the dash lights fuse from blowing.
Parking Lights-                 
Hazards      same as turn signal wires            
Turn Signal(L)      BLACK/ white       +       turn signal switch
Turn Signal(R)      BLACK/ green       +       turn signal switch
Reverse Light                 
Door Trigger      BROWN / yellow       -       theft module
Notes: The theft module is located to the left of the steering column.
Dome Supervision      same as door trigger            
Trunk/Hatch Pin      BROWN / black       -       theft module
Notes: The theft module is located to the left of the steering column.
Hood Pin      BROWN / red       -       theft module
Notes: The theft module is located to the left of the steering column.
Trunk/Hatch Release                  theft module
Notes: Use BROWN / purple negative trigger on models with power windows, or RED / blue 5-wire positive on models without power windows. The fuel door can be released with a positive trigger on blue/red at the release switch.

The theft module is located to the left of the steering column.
Power Sliding Door                 
Factory Alarm Arm      arms with lock            
Factory Alarm Disarm      disarms with unlock            
Disarm No Unlock                 
Tachometer      GREEN/ YELLOW             ignition coil
Notes: Can also be found as GREEN/ brown behind the instrument cluster in a blue plug.
Wait to start                 
Brake Wire      RED / black       +       brake switch
Parking Brake                 
Horn Trigger      BLACK / YELLOW       +       theft module
Notes: The theft module is located to the left of the steering column.
Memory Seat 1                 
Memory Seat 2                 
Memory Seat 3                 
Interface Module:      Category:
Immobilizer Bypass      Required:
No      Type:
N/A
Part #: N/A
Notes:
Interface Module:      Category:
Door Lock Interface      Required:
No      Type:
Data Bus
Part #: IM-Volkswagen-1
Notes:
Smart Starter Kill Relays: Not Available


warning      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.







Print Page | Close Window