Print Page | Close Window

Autopage RS-860 LCD

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87617
Printed Date: May 10, 2025 at 4:17 AM


Topic: Autopage RS-860 LCD

Posted By: dago52
Subject: Autopage RS-860 LCD
Date Posted: December 21, 2006 at 11:47 PM

I finally received my autopage remote start alarm. I will be attempting to install this alarm in my 2006 4Door  Toyota Tundra. I have a few quick questions before trying to tackle this project.

Do I have to remove the factory keyless entry first?

Should I mount the brain on the driver or passenger side?

Sould I skin and solder the wires to the main harness?

Will I need any relays or diodes for the door locks/lights/remote start?

Thanks for all of the help




Replies:

Posted By: mlaurenza
Date Posted: December 22, 2006 at 7:04 AM

Do I have to remove the factory keyless entry first?   Nope

Should I mount the brain on the driver or passenger side?   Drivers side. Most all the wires are on the drivers side.

Sould I skin and solder the wires to the main harness? Absolutely

Will I need any relays or diodes for the door locks/lights/remote start? If it is a double cab you will need relays and diodes for door locks. The factory remote will not unlock the doors when remote started so you have to hook up keyless or you will have to use the key to get in when remote started. Get the wires in the door.

Thanks for all of the help




Posted By: KarTuneMan
Date Posted: December 22, 2006 at 8:49 AM
PASSIVE ANTI-THEFTYESTRANSPONDER SEE NOTES
12 VOLTSWHITE/ blue & WHITE/ redIgnition switch harness +
Wires may change color through a connector on the steering column. Please verify both sides of the connector for these colors.
IGNITIONBLACK/ redIgnition switch harness +
Wires may change color through a connector on the steering column. Please verify both sides of the connector for these colors.
IGNITION 2BLACK / YELLOWIgnition switch harness +
Wires may change color through a connector on the steering column. Please verify both sides of the connector for these colors.
ACCESSORYPinkIgnition switch harness +
Wires may change color through a connector on the steering column. Please verify both sides of the connector for these colors.
STARTERBLACK/ whiteIgnition switch harness +
Wires may change color through a connector on the steering column. Please verify both sides of the connector for these colors.
KEY SENSEYELLOW /GREENAt steering column -
TACH SIGNALYELLOW /GREENPin-4 on 28-pin plug at ECM behind glovebox AC
CRANKSHAFT POSITION SENSORGreenPin-23 on 31-pin plug at ECM behind glovebox
FUEL INJECTOROpposite from BLACK/ redAt any injector on engine AC
LOCKLt.GREEN/ blackInside driver's door at switch -
This vehicle requires a special configuration for the doorlocks, please see the doorlock diagram.
UNLOCKLt.GREEN/ red & RED / yellowInside driver's door at switch -
This vehicle requires a special configuration for the doorlocks, please see the doorlock diagram.
DOORPINSEE NOTES
All the following wires are found at the BODY ECU under the driver's side dash to the far left. WHITE (pin-8 on 18-pin plug) catches all doors. For separate door triggers, use GRAY/RED (pin-15) Driver's door, RED / WHITE (pin-16) Rear left door, both found on 18-pin plug. LT.GREEN/ BLACK (pin-8) Passenger door, RED / WHITE (pin-4) Rear right door, both found on 25-pin plug.


-------------



Posted By: KarTuneMan
Date Posted: December 22, 2006 at 8:50 AM
 HOODPIN Blue/white In large white connector in DKP   - 
 TRUNK PIN Red In back door at ECU module   - 
 FACTORY ARM Arms with lock wire     
 FACTORY DISARM Disarms with unlock wire     
 BRAKESWITCH GREEN / WHITE On Gray plug in driver's kickpanel   + 
 PARKLIGHTS Green On Black plug in driver's kickpanel   + 
 HAND BRAKE Lt.GREEN/ red At switch on handbrake lever   - 
 HORN BLACK / YELLOW At steering column   - 
 DRIVER WINDOW UP Red At switch in driver's door   REV POL 
 DRIVER WINDOW DOWN Green At switch in driver's door   REV POL 
 PASSENGER WINDOW UP Red At switch in passenger door   REV POL 
 PASSENGER WINDOW DOWN Green At switch in passenger door   REV POL 
 LEFT REAR WINDOW UP Red At switch in left rear door   REV POL 
 LEFT REAR WINDOW DOWN Green At switch in left rear door   REV POL 
 RIGHT REAR WINDOW UP Red At switch in right rear door   REV POL 
 RIGHT REAR WINDOW DOWN Green At switch in right rear door   REV POL 
 HEADLIGHTS GREEN/ YELLOW Pin-15 on 20-pin plug at ECM behind glovebox   - 
 REVERSE LIGHTS RED / black In driver's kickpanel   + 
 VSS WIRE GREEN/ orange Pin-5 on 28-pin plug at ECM behind glovebox     


Available Notes
Vehicle Notes 
PLEASE NOTE: This vehicle is equipped with a TRANSPONDER passive anti-theft system. A keyless bypass module may be available, contact your supplier to find out. If one is not available to you, please refer to the appropriate security diagram for bypass information.
Additional Notes 
WHEN PROGRAMMING THE PATS TOYOTA THE BLACK WIRE FROM PATS TOYOTA MODULE TO GROUND FIRST. AFTER THE BLACK WIRE IS GROUNDED GROUND THE BLUE KEY SENSE WIRE ON THE IGNITION BARREL. DO NOT GROUND AT THE SAME TIME.


-------------


Print Page | Close Window