06 Chrylser 300 remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87859
Printed Date: May 13, 2024 at 9:27 PM
Topic: 06 Chrylser 300 remote start
Posted By: ls1nova
Subject: 06 Chrylser 300 remote start
Date Posted: December 27, 2006 at 9:29 AM
What is everyone using for 12v source on these? The 12v at ign switch is good for 15 amps. Is that enough, or should I go elswhere? The only thing pulling any current should be the parking lights. Thanks, Frank
Replies:
Posted By: captainzab
Date Posted: December 27, 2006 at 10:22 AM
12v at the ignition is the best place to grab it.
-------------
Note: You Always Dont Get What You Pay For.
Posted By: splaudio
Date Posted: December 27, 2006 at 2:17 PM
anything under 30amps i go directly to the battery...
Posted By: ls1nova
Date Posted: December 27, 2006 at 2:22 PM
Thanks guys. I'm all done. I went right to the ign swich 12v source. It is only a 15a circuit, but I'm really now powering anything but relays so I used it. Works great. These 300's really aren't bad to do at all. Thanks, Frank
Posted By: green6767
Date Posted: December 27, 2006 at 6:53 PM
The power source at the ignition probably isn't the best one. There is a better power source in the passenger kick panel. If you run two wires over there, you can get positive parking lights there too. Thick Red wire or power, and WHITE/ purple for positive parking lights. Just my way of doing them, but I feel better knowing the power source is for sure not going to fail and cause problems down the road.
-------------
Shaun, we are the same height, that is neat!
12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.
|