04 lexus rx330 remote start wiring loc
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87878
Printed Date: May 11, 2025 at 11:26 PM
Topic: 04 lexus rx330 remote start wiring loc
Posted By: subywrxdude
Subject: 04 lexus rx330 remote start wiring loc
Date Posted: December 27, 2006 at 4:49 PM
hi, im installing a remote start in my mom's 2004 lexus rx 330 and i cant find the hood pin - input, the diagram says its in the driver kick gray harness that the wire is black to red, but im looking at the kick panel and there's not gray harness? Also, the unit is a DEI hornet system and where do it tap into for the wire that says (-) remote start activation input?
Replies:
Posted By: kgerry
Date Posted: December 27, 2006 at 5:08 PM
there often isnt a connector for a factory hood pin... i always install my own..... also, you dont need to hook up the - activation wire... this is there in case you want a different device to activate the R/S unit..... ------------- Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: subywrxdude
Date Posted: December 27, 2006 at 5:41 PM
usually for the immobilizer, the 556u unit, do you guys just install the atenna ring before the transporter? Or cut the ring and wire it to the transporter? The unit also ask to insert a key into the interface too? why is that?
Posted By: profuse007
Date Posted: December 27, 2006 at 10:36 PM
556u required a spare key. don't cut the transponder ring. its a universal bypass module, therefore required a key. id use a keyless bypass 555f or pkt, if compatible.
Hood Pin red to black (-) driver kick, gray 18 pin plug
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
|