2006 kia rio tach wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=87921
Printed Date: May 13, 2025 at 6:26 PM

Topic: 2006 kia rio tach wire

Posted By: peddy
Subject: 2006 kia rio tach wire
Date Posted: December 28, 2006 at 9:46 AM

have most of my remote start installed, still cant find a tach wire, when testing for a tach wire will the readout go up when i step on the gas?

Replies:

Posted By: GregK
Date Posted: December 28, 2006 at 9:55 AM

This what I have for your car:

TACH BROWN / RED @ DIAGNOSTIC PLUG UNDER DRIVER DASH

Hope it helps.

Posted By: peddy
Date Posted: December 28, 2006 at 9:57 AM

thank you, back to work =)

Posted By: peddy
Date Posted: December 28, 2006 at 10:17 AM

=/ no BROWN / red on the port. i do have a blue thats reading arond 5 but it reads that with the key truned to on befor starting, and stays power for about 3 sec after truning the car off. could this be it?

Posted By: GregK
Date Posted: December 28, 2006 at 10:42 AM

No, that wouldn't be it. You should see 0V when not running and between 1.5 and 6V when running. The voltage will fluctuate with the engine RPM.

Posted By: peddy
Date Posted: December 28, 2006 at 12:31 PM

thank you, got one off the back of the cluster, now i just need to find out how to get the rear defrost to come on with the start and its good to go, thankz for all the help.

Print Page | Close Window