I did an install for a 99 mercury villager and i had a problem with the door locks. On one of my paper works it says red for lock and RED / black for unlock but it says negative and it says to find it in the door harness. but on the another paper work it says that its a positive so im confused if its a negative or a positive. Any help is appreciated and thanx in advance.
this is one of the paper works.
Door Lock | Red (+) | 10 Pin Connector Driver's Door Boot |
Door Unlock | RED / Black (+) | Positive Door Trigger |
Driver's Lock | GREEN/ YELLOW | Left Kick Panel |
Driver's Unlock | WHITE/ Green | Left Kick Panel |
Passenger Unlock | WHITE/ Red | Right Kick Panel |
the other one is
power lock-----red---------(-) either door harness
power unlock------RED / black-----------(-)either door harness
see why im confused..
-------------
Confidence is the key to any project!!
test with a dmm for sure.
-------------
im just confused cause i dont know if i should try the red and RED / black or other wires. I used the dmm and with one it would go from 0 to 12 volts but then when i connect the alarm it would not lock or unlock so just wondering if i should stay with red and RED / black or the other wires the paper work says.
-------------
Confidence is the key to any project!!
Dei list it as negative need to test by turning key in cylinder.
Do you know which colors the wires would be..
-------------
Confidence is the key to any project!!
I find DEI wiring info is always very accurate, but I always test all wires with a DMM-You need to, unless you did the same car yesterday & even then it's a good idea to check again.
power lock-----red---------(-) either door harness
power unlock------RED / black-----------(-)either door harness
Notes: Meter this wire while turning the key in the door key cylinder.
These are the wires that are the easiest to use.
-------------
Good Enough Isn't!