2003 ford focus clutch bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=88121
Printed Date: July 06, 2025 at 2:28 AM

Topic: 2003 ford focus clutch bypass

Posted By: oakley2000sel
Subject: 2003 ford focus clutch bypass
Date Posted: December 31, 2006 at 2:30 PM

I installed the r/s everything is ready to go except for the clutch bypass. Does anybody know how and which wires I need on the clutch switch? Thanks in advance.

Replies:

Posted By: Ravendarat
Date Posted: December 31, 2006 at 2:46 PM

There is a black plug at the clutch with two BLACK/ red wires, the one you need is the top one. You need to send a negative pulse to that wire at the same time as you send the positive signal to the starter wire in the column. If your starter has a negative start output like a compustar then use that, if it does not you can use a relay and use the positive starter wire as your trigger.

-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer

Posted By: oakley2000sel
Date Posted: December 31, 2006 at 4:52 PM

Thanks that worked great! Now running into another situation. I purchased the PKF2 Bypass Kit from 12 volt. Hooked it up but when attempting to r/s the vehicule just keeps cranking. I know it's the bypass because it will start using r/s with the key in the ignition. I pulled the connector off the PATS module and I assumed I had the TYPE B so that's how I hooked it up. Does anybody know what type the connector is? There is TYPE A, B, C, D. Thanks again!

Print Page | Close Window