I am putting in a DEI 711T keyless entry system in a 94 mercury villager
I was wondering what exactly the lock and unlock motor go to and where the door trigger hooks up to. Im thinking the lock and unlock moter go to the common #30 on the 8 pin connector?? Also not really sure what wire in the car is for the domelight?
These are the wires from the brain and where i think they go
12-pin
1/1 orange (-) 500 mA Armed output / Don't think i use
1/2 white (+/-) Parking Light Output / hook up to pink ( MIGHT BE PINK/BLACK)
1/3 WHITE/ blue (-) 200 mA channel 3 validity output / Don't think i use
1/4 BLACK/ white output of domelight supervision relay #30 / Not sure if i use? (USED DIRECTLY TO DOMELITE WIRE THIS WILL ILLUMINATE THE INTERIOR LIGHTS WHEN DISARMED)
1/5 green NO FUNCTION
1/6 Blue (-) 200 mA Second unlock output / Don't think i use
1/7 violet NO FUNCTION
1/8 black / ground
1/9 yellow (+) switched ignition input / hook to white-red wire
1/10 brown (-) horn honk output / hook to black wire
1/11 red (+) power
1/12 RED / white output of channel 2 relay #30 / Not sure if i use?
8-pin
2/a RED / white channel 2 relay input #87
2/b BLACK/ white Domelight Supervision relay input #87 (GROUND)
2/c WHITE/ black lock #87a normally closed (NOT USED)
2/d GREEN/ black lock #30 common (output) (TO DOOR LOCKS WIRE)
2/e violet/black lock #87 normally open (input) (GROUND)
2/f BROWN / black unlock #87a normally closed (NOT USED BUT TREMINATE WITH CONNECTOR)
2/g blue/black unlock #30 common (output) (TO DOOR LOCKS WIRE)
2/h violet unlock #87 normally open (input) (GROUND)
Thanks for the help
everything is correct,in all tose wires that you say "don't sure if i use"you dont need it,the orange wire is for your starter kill relay,just if you wanna have it use it.about the dome light let us know if theres dome light delay in that car,and we go from there.
-------------
el camino
on the tech sheet it says grounded at rest thru dash ind. - use diode to isolate. RED / black (-) wire in the drivers A pillar is the domelight output from timer. Gets all doors but reads delay. There is also a blur (-) in the center console that catches all the doors on keyless models.
also do i use the door trigger wire if so where do i hook it up to on the brain??
You don't need door trigger if you're only doing keyless entry.
But if you want the domelight to come on when you unlock the doors, tie the wire labeled as 2/b to a ground, and tie the 1/4 wire to the negative side of any courtesy light in the car......if there's an underdash courtesty light, (which most Nissans don't have though), that'd be the easiest place to get it. You'll probably be best to get the RED / black at the A-pillar.
so the lock motor and the unlock motor go to the commom #30 wires on the brain correct??
I do want the domelight to come on so do i hook up the RED / black wire in the A piller to the domelight on the brain??
use a relay for the domeligth,because the current from the brain is not to strong.and yes to the other question.
-------------
el camino