Remote start, 94 civic
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=88245
Printed Date: May 05, 2025 at 10:23 AM
Topic: Remote start, 94 civic
Posted By: iceman7329
Subject: Remote start, 94 civic
Date Posted: January 02, 2007 at 7:38 PM
I plan on installing a Clifford Matrix 50.5X Responder SST in my 94 Civic soon. I want to do window roll up, down modules on all 4 windows also. Does anyone have wiring info for this car? Its an LX automatic if it matters. Thanks.
Replies:
Posted By: Twelvoltz
Date Posted: January 02, 2007 at 8:15 PM
DEI lists the following for windows:
LF Window up/dn RED / yellow - RED / blu A drivers switch
RF Window up/dn blue/yel - blue/grn A drivers kick panel
LR Window up/dn yellow - yellow/grn A dkp, harness to rear
RR Window up/dn yellow - yellow/grn A dkp, harness to rear
Alarm information can be found in the wiring database in the diagrams section.
Posted By: rudydapimp
Date Posted: January 02, 2007 at 8:16 PM
LF Window Up RED / YELLOW (REV) DRIVERS DOOR SWITCH
LF Window Dn RED / BLUE (REV) DRIVERS DOOR SWITCH
RF Window Up BLUE / YELLOW (REV) DRIVER KICK PANEL
RF Window Dn BLUE (REV) DRIVER KICK PANEL
Posted By: iceman7329
Date Posted: January 02, 2007 at 8:18 PM
Thanks, and I found the other info after looking around on the site.
Posted By: iceman7329
Date Posted: January 03, 2007 at 6:25 PM
I just put a Aftermarket Generation remote starter on my 94 civic. https://aftermarketgeneration.com/catalog/product_info.php?cPath=23_80&products_id=32&osCsid=b95807c59b473c8e604409aefb7972aa I didnt hook up the brake pedal switch yet, or the key on input. I used the (-) wire of the two for the door trigger input. If I try to remote start the car with the door shut the alarm just goes off. If the door is open it will start but then cut back off, it will then start and stop 2 more times on its own. I hae no idea what Ive done wrong. I need this working in like an hour. Ideas? I also just grounded the hood pin switch wire for now as I dont have a switch, that wont cause this will it? It would be grounded anyways right?
Posted By: cpgoose
Date Posted: January 03, 2007 at 6:54 PM
For the hood pin switch, it will see a negative (ground) signal when the hood is open, which would either prevent the car from remote starting or turn off the car if it is running and the hood opens. So, I think if you don't use the hood pin wire you should just tape it off and not ground it. If you ground it, I think it won't start.
As for the brake pedal or key on input wires, I'm not really sure I follow what you say you're doing there.
Posted By: iceman7329
Date Posted: January 03, 2007 at 6:56 PM
Ok, I read the manual again and it says it wont work unless the hood pin wire is grounded so thats right. On the brake and key wire I just havent hooked those up. I cant get my big ass under the dash of this car.
Posted By: iceman7329
Date Posted: January 03, 2007 at 8:47 PM
Nevermind, its been one of those days. Its working perfect now.
|