Autopage RS-750lcd 2000 silverado
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=8840
Printed Date: June 25, 2025 at 7:02 PM
Topic: Autopage RS-750lcd 2000 silverado
Posted By: raneycain
Subject: Autopage RS-750lcd 2000 silverado
Date Posted: January 30, 2003 at 5:05 PM
What antitheft system do i have.... is it passlock II? does anyone have wiring diagrams for my truck?
Replies:
Posted By: jayts95
Date Posted: January 30, 2003 at 7:02 PM
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|red |+ |ignition harness |
| STARTER|yellow |+ |ignition harness |
| IGNITION|pink |+ |ignition harness |
| SECOND IGNITION|white |+ |ignition harness |
| ACCESSORY|orange |+ |ignition harness |
| POWER LOCK|lt. blue |+ |brown plug at BCM *1 |
| POWER UNLOCK|white |+ |brown plug at BCM *1 |
| LOCK MOTOR|gray | |drivers kick panel |
| UNLOCK MOTOR|tan | |drivers kick panel |
| DISARM DEFEAT|tan/black | |passengers kick panel |
| PARKING LIGHTS +|brown | |lt. blue plug at BCM *1 |
| PARKING LIGHTS -|white | |lt. blue plug at BCM *1 |
| HEADLIGHTS|white |+ |lt. blue plug at BCM *1 |
| DOOR TRIGGER|*2 |- |BCM *1 |
|FCTRY ALRM DISARM|lt.green |- |drivers kick *4 |
| TACHOMETER|white *5 | |ECM *3 |
| SPEED SENSE|dk.GREEN / WHITE | |ECM *3 |
| BRAKE WIRE|white |+ |brake pedal switch |
| HORN TRIGGER|black |- |brown plug at BCM *1 |
| WIPERS| | | |
| LF WINDOW UP/DN|blue - brown |A |drivers door switch |
| RF WINDOW UP/DN|blue - brown |A |passenger door switch |
| LR WINDOW UP/DN| | | |
| RR WINDOW UP/DN| | | | Notes:
NOTE: If you have a 2000 Classic Pickup, refer to the 1998 Full Size Pickup. NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use DEI part 555t or 555L. *1 The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The parking lights are in pin A5 and the headlights are in pin A11. *2 Use tan for the drivers door located in pin B4 of the purple plug, and for the passenger door it will be a orange in pin B2 in the purple plug or dk.blue/white in pin B11 of the lt.blue plug, must diode isolate these wires. *3 ECM is located near the battery, down low, between the fender and the fan under the black plastic cover. On the 4.3L, the tach wire is at pin 20 in the connector labeled 'red', and VSS wire is at pin 3 in the connector labeled 'black'. On the 4.8L, 5.3L, and 6.0L, the tach wire is located at pin 10 in the 'red' connector, and VSS wire is located in pin 50 of the 'red' connector. *4 Also found in the purple plug of the BCM. *5 Diesel wait to start wire is dk. blue (-) located at the instrument cluster 'see direct fax document #1090'. -------------
Posted By: securinu
Date Posted: January 30, 2003 at 8:20 PM
yes it is passlock 2 the best bypass is the databus one power ground and databus very simple.
Posted By: raneycain
Date Posted: January 30, 2003 at 10:19 PM
thanks.... where can i get that?
Posted By: floaterr
Date Posted: February 20, 2003 at 10:36 PM
Whats with the 2 parking entries?
| PARKING LIGHTS +|brown | |lt. blue plug at BCM *1 |
| PARKING LIGHTS -|white | |lt. blue plug at BCM *1 |
Is that my choice for positive or negative activation or for left/right?
Also is there a 3rd ign (brown)?
Thanks for your help
Posted By: Velocity Motors
Date Posted: February 21, 2003 at 7:57 AM
You can tie into either one of the parking light wires ( depending on what your unit outputs as polarity ). The 3rd IGN wire is only for wipers, not really necessary for RS installations.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: jrilla
Date Posted: February 21, 2003 at 9:18 AM
RainyCain, the bypass kit is called the PLDATA and you can check it out here: Follow links to purchase though.
www.bypasskit.com
-------------
J Rilla
Owner/Installer
Posted By: floaterr
Date Posted: February 21, 2003 at 2:05 PM
Last thing.. I don't see and entry for dome lights. Do you know which wire it is? Or should I just put negative to one of the door triggers?
Posted By: Velocity Motors
Date Posted: February 21, 2003 at 2:28 PM
Use the TAN/LIGHT BLUE wire for all door trigger found at the keyless module below steering column. This will be a (-) trigger so you can tie in the domelight function from the RS to this wire.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|