I'm in the process of trying to get a compustar 2w900fm as into a 95 mazda mx3. Everything seems to work fine other than the remote start. I tell the car to start and it gets stuck on the on position where the warning lights are on but the starter doesn't turn. I have all the ignition wires hooked up along with, foot brake, door trigger, tach sensing wire. The car is an automatic and does have an automatic brain with it. I followed compustars directions to the T from there install manual. Any help is greatly appreciated thanks in advance,
max
| Wire/Function | CM3000 | Colour | Location/Description | Polarity |
| 12 VOLTS | RED (CN1) | Black | Ignition harness | + |
| IGNITION | GREEN (CN1) | Blue | Ignition harness | + |
| IGNITION 2 | GREEN (CN2) + Relay | BLACK/ red | Ignition harness | + |
| ACCESSORY | WHITE (CN1) | BLACK/ white | Ignition harness | + |
| STARTER | YELLOW (CN1) | BLACK/ blue | Ignition harness | + |
| KEY SENSE | | Blue/red or White | Ignition harness | - |
| TACH SIGNAL | YELLOW/BLACK (CN3) | Yellow/blue | At coil or distributor | AC |
| LOCK | BLUE/BLACK (CN4) | Must add actuator | | |
| UNLOCK | BLUE (CN4) | Must add actuator | | |
| DOORPIN | RED / WHITE(-) or RED(+) (CN3) | RED / white | At either pinswitch | - |
| TRUNK PIN | VIOLET/BLACK (CN3) | Red | At light in trunk | - |
| TRUNK RELEASE | VIOLET/WHITE (-) (CN4) | Manual release | | |
| BRAKESWITCH | LT.BLUE/WHITE (CN3) | Green | At switch above brake pedal | + |
| PARKLIGHTS | GREEN / WHITE (+) (CN1) or (-) (CN2) | RED / black | At fusepanel | + |
| HORN | WHITE (-) (CN5) | GREEN/ black | At steering column | - |
| DRIVER WINDOW UP | | RED / black | At main window switch | REV POL |
| DRIVER WINDOW DOWN | | RED / green | At main window switch | REV POL |
| PASSENGER WINDOW UP | | RED / white | At main window switch | REV POL |
| PASSENGER WINDOW DOWN | | BLACK/ blue | At main window switch | REV POL |
| HEADLIGHTS | | RED / blue | At light switch harness | - |
| REVERSE LIGHTS | | RED / green | In driver's kickpanel | + |
| DIMMER | | Red | At dimmer switch harness | |
| VSS WIRE | | PURPLE / white or PURPLE / orange | At ECM behind center console | |
Heres the tech sheet FROM Compustar, it shows the wires color from their brain, and where to connect it on YOUR car.
-------------