Remote Starter, 2002 Chevy Tracker
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=88697
Printed Date: May 03, 2024 at 5:40 PM
Topic: Remote Starter, 2002 Chevy Tracker
Posted By: zombie69
Subject: Remote Starter, 2002 Chevy Tracker
Date Posted: January 10, 2007 at 6:18 AM
I just Installed a Prestige APS-686T remote starter in a 2002 Chevy Tracker. The problem I am haveing is the Tach signal, The Tracker has 4 individual coils 1 for each cyclinder. The Instalation manual says I might havre to hook the tach wire to multiable coils see mutiple coil wiring. And says I need (P/n 136b1400) to hook all the coils together. But were do I get this adapter? And do I need it? Thanks
Replies:
Posted By: brhaugen
Date Posted: January 10, 2007 at 6:41 AM
You should not need any adapters. Tach is the brown wire Pin4 of the C1 Connecter at the PCM - PCM is behind the gove box
Posted By: zombie69
Date Posted: January 10, 2007 at 4:14 PM
I will try and let you know what happens thanks.
Posted By: zombie69
Date Posted: January 15, 2007 at 7:11 AM
I tried hooking into the brown wire pin 4 of the PCM but still have the same problem? Car will start but will not stay running? Any help would help thanks.
Posted By: xtremej
Date Posted: January 15, 2007 at 8:19 AM
Are there multiple brown wires at the ECM thats behind the glove box? Did you verify with a multimeter that you in fact are on the right one. Is you remote start set to sense tach? I checked all of my diagrams and they all call for the brown at the ECM behind the glove box.. -------------
Posted By: Hymer
Date Posted: January 15, 2007 at 8:51 AM
Looks like the 3rd wire top row of the 1st plug [left to right] under the glove box
-------------
Tire Proz Stillwater Mn
High End Restyling and Comlete Repair
Posted By: zombie69
Date Posted: January 15, 2007 at 12:26 PM
What should be my reading on the meter? And what do i set the meter for? Thanks
Posted By: xtremej
Date Posted: January 15, 2007 at 3:00 PM
well i set my meter to voltage and usualy it will read between 1.6 volts or so and then rev it up a little and the voltage should raise.
-------------
Posted By: zombie69
Date Posted: January 15, 2007 at 3:31 PM
Thanks for the help will try and post what happens. Thanks Again
Posted By: mbaudio06
Date Posted: January 15, 2007 at 3:40 PM
I would try the cluster..
Posted By: Mike M2
Date Posted: January 15, 2007 at 5:00 PM
mbaudio06 wrote:
I would try the cluster..
I agree, but it's even easier than that. You can follow the harnees from the cluster down the left side of it and catch it there. You don't even have to pull it out... ------------- Mike M2
Tech Manager
CS Dealer Services
Posted By: zombie69
Date Posted: January 21, 2007 at 3:41 PM
Thanks all for the help. I have it going now thanks again
|