Print Page | Close Window

2004 jeep grand cherokee

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=88736
Printed Date: May 19, 2024 at 6:11 PM


Topic: 2004 jeep grand cherokee

Posted By: northern
Subject: 2004 jeep grand cherokee
Date Posted: January 10, 2007 at 8:14 PM

Did this vehicle today. I first did it using a relay and a little over 1000k ohms resistor and the parking lights only come on when you press the lock and unlock button but not when you remote start the vehicle.

Then I decided to goto the relay that astrostart says to go to and did a negative output. This didn't work, everytime I made a connection it would lock the autostart up and not allow anything to work till you cut the connection to the relay.

Has anyone used the "hazards" on this vehicle and got them to work?



Replies:

Posted By: KarTuneMan
Date Posted: January 10, 2007 at 10:27 PM
What are you installing?????  Did you "break" the wire with the relay? cut the wire, switch side to 87a car side to 30, 1000ohm resistor to 87 and grond. pin 85 gets grounded as well and 86 gets the POS(+) parking light wire from your unit. If this is what you did....it should work perfectly.

-------------




Posted By: start25
Date Posted: January 11, 2007 at 1:04 AM

I installed one today on same car it was Autopagers-727 and all I did was cut the RED / white wire hooked it up to ground and parking light attached to - parking wire though like 1000 ohm resistor... when car is started it doesnt come on like for 10 sec. then it comes on....





Posted By: start25
Date Posted: January 11, 2007 at 1:06 AM

The only thing I have problem with is door trigers...how did u hook those up?





Posted By: mikvot
Date Posted: January 12, 2007 at 11:08 PM
the park lights require 2 k, or u can use blue/red at steering column......flashes hazards. As for the door triggers. drivers door-tan red in door at switch.     pass door-tan red in pass. door.    rear drivers side-tan/orange at drivers kick.    rear passenger-tan / YELLOW at back of bcm on bottom connector. rear hatch is tan black at front of bcm. use a relay to isolate

-------------





Print Page | Close Window