AstroStart’s manual interface module?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=88868
Printed Date: May 13, 2025 at 1:03 AM
Topic: AstroStart’s manual interface module?
Posted By: green6767
Subject: AstroStart’s manual interface module?
Date Posted: January 13, 2007 at 10:17 AM
im installing an AstroStart 2101 on a 98 Jeep Wrangler manual transmission. I normally dont do manual transmissions because of the pain with em. The cluth bypass shouldn't be a problem, direct hookup from the starter wire from the astrostart. I am using Astrostart's manual interface module and its throwing me for a loop here. the diagram shows configurations for multiple kinds of setups....and i'm having a hard time figuring this one out. The Jeep only has two doors, and I have found and tested the door pins. Shows positive when door is shut,and negative when door is open. Does anybody know how I would go about using the manual interface with the door pins? The remote starter itself, clutch bypass, and e-brake monitoring shouldn't be an issue. Just how to hook up the interface to the 2 door pins. Thanks for any help guys!!!
-------------
Shaun, we are the same height, that is neat!
12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.
Replies:
Posted By: KarTuneMan
Date Posted: January 13, 2007 at 11:08 PM
The white door pin wire NEG(-) goes to the door pin wire. The purple POS(+) door pin, goes to 12V. You need to "use" both. If you had POS(+) door triggers, you would co0nnect the white door pin wire to ground.....you see, use both. Yes, take the dark blue starter wire to the yellow/red @ the clutch switch. The green from the Manual modual, goes to the grey/black in the center console for the ebrake. Let me know if you need ANY more help...I believe in this product. -------------
Posted By: green6767
Date Posted: January 15, 2007 at 3:38 AM
i got it figured out before i read the response to my post. I did exactly as you posted! It was way too easy..i was just overthinking it. Its actually a great product and i would consider doing more manual transmissions with this thing. Thanks for the reply though!
-------------
Shaun, we are the same height, that is neat!
12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.
|