95 jetta ignition lock being a prob w RSt

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=89566
Printed Date: July 15, 2025 at 9:04 PM

Topic: 95 jetta ignition lock being a prob w RSt

Posted By: hotlead44
Subject: 95 jetta ignition lock being a prob w RSt
Date Posted: January 25, 2007 at 11:13 PM

I have this jetta with remote start installed. The issue is that when remote is started and then the key is inserted into the ignition the doors lock and then the factory alarm becomes armed. then opening a door sets off the horn with the key still in.

I need to get rid of the factory alarm or turn of the ignition locking. and I know that its armed with the locks so any ideas, thanks a lot

Replies:

Posted By: profuse007
Date Posted: January 25, 2007 at 11:33 PM

new installation?

whats the RS unit make/model?

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: KarTuneMan
Date Posted: January 25, 2007 at 11:38 PM

On the factory alarm module you need to "break" the ignition INPUT wire. It's pin 4 and black. It's under the drivers side dash kind behind the light switch. there are a 10mm bolt to get the box to drop down. Cut the black pin 4 ign. input wire, put one end on pin 87a, and the other end on 30. Pin 85 gets 12volts, pin 86 gets ground while running, or status output (DEI). Just remeber ground while running to trigger the relay!

-------------

Posted By: hotlead44
Date Posted: January 26, 2007 at 12:55 PM

ima give it a shot, thanks for taking the time.

Print Page | Close Window