2007 toyota rav4 alarm/remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=89665
Printed Date: May 15, 2025 at 9:41 PM

Topic: 2007 toyota rav4 alarm/remote start

Posted By: pasik1
Subject: 2007 toyota rav4 alarm/remote start
Date Posted: January 27, 2007 at 10:22 PM

Lookin for wiring brand new Toyota rav 4 2007 for installation car alarm& remote starter! have some problem with driver door window rollup, no wires going to motor(module seets on motor) so just thin wires going inside motor module, negative during rollup on just one wire,but after release switch wire rests on "+"(CONNECTOR 8 WIRES)

Anybody help!!!!!

Replies:

Posted By: imseth85
Date Posted: January 28, 2007 at 12:59 AM

https://www.designtech-intl.com/main.asp

go here....use the newest rav-4 info they have. The wires going to the motor probably go to a relay first if they are really thin, but I haven't seen the inside of that door before.

-------------
Seth Alvo NY
Mobile Electronics Installer

Posted By: Mike M2
Date Posted: January 28, 2007 at 9:46 AM

I don't know it's possible. It's certainly an unusual design, 3 windows are normal 5 wire restat ground but the drivers seems to work from data from the drivers switch. Maybe you could open the switch module up and solder wires right to the switch itself?

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: pasik1
Date Posted: January 29, 2007 at 11:02 AM

Thanks for quick responding! I think about feeding that door, swich is OK,but how about "+" on doors module -it stays energized all time? posted_image

How about sunroof? any idea for wire colours for closing?

Print Page | Close Window