dei 561t in 2000 durango
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=89854
Printed Date: July 04, 2025 at 4:47 PM
Topic: dei 561t in 2000 durango
Posted By: bulldog65
Subject: dei 561t in 2000 durango
Date Posted: January 31, 2007 at 10:08 PM
I am installing a DEI 561T Addon Remote Start into a 2000 Dodge Durango. The problem I am having is with the activation input. I have it connected to the Door Lock Wire (ORANGE / Black), and it works if I pulse the door lock, but it will not activate when pulsed from the remote. Would I need to connect this to Factory Alarm Arm? What color, and where is this wire located?
Replies:
Posted By: Twelvoltz
Date Posted: February 01, 2007 at 6:27 AM
You would use the WHITE/ red + activation input. Connect this wire to the ORANGE / black in the driver's kick panel, door harness. This wire is the wire that is the actuator supply wire. This wire rests at ground and goes to +12V when locking. It is the actuator leg, and if the door is locking it will provide +12V no matter what method you use for locking, door switch or remote. It sounds as if you may be on the incorrect wire.
Posted By: bulldog65
Date Posted: February 01, 2007 at 7:41 AM
I am using he RED / white activation input wire, and have it connected the the ORANGE / black wire. This wire pulses 12+ when triggered with the lock switch, but doesn't pulse when triggered with the remote. I will look for other ORANGE / black wires to see if I am hooked into the wrong one.
Posted By: bulldog65
Date Posted: February 01, 2007 at 8:35 AM
sorry, I'm using the WHITE/ red wire.
Posted By: Twelvoltz
Date Posted: February 01, 2007 at 9:23 AM
The proper ORANGE / black will pulse no matter how the locks are activated as it is the leg from the actuator.
Posted By: bulldog65
Date Posted: February 01, 2007 at 12:23 PM
Ok I got the correct wire now, and the RS activates via the remote now. The only issue remaining is with the alarm disarm wire. I believe this is a light GREEN/ orange wire. Is this a direct connection to the 561T, or are resistors required?
Posted By: Twelvoltz
Date Posted: February 01, 2007 at 12:26 PM
You need a relay wired like:
85: GREEN/ Black FAD from 561T
86: Constant fused +12V
30: Ground
87: through 1562ohm resistor to light GREEN/ orange in kick panel
Posted By: bulldog65
Date Posted: February 01, 2007 at 1:05 PM
How do you test this wire? Does this wire pulse 12+ on unlock(disarm)?
Posted By: bulldog65
Date Posted: February 01, 2007 at 7:07 PM
Install complete. thanks for the help!
|