1992 240sx se remote start trouble

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=89897
Printed Date: June 05, 2024 at 1:04 PM

Topic: 1992 240sx se remote start trouble

Posted By: grizeg
Subject: 1992 240sx se remote start trouble
Date Posted: February 01, 2007 at 5:12 PM

I'm installing a Viper alarm system into a 1992 240sx SE, when i hit the remote start button the ignition cuts on, and the lights on the dash light up, my seat belts also go back, but the car does not start. i have read in areas that this car has 2 ignitions i can not find the second, any ideas as to where its located or, what i might be doing wrong?

-------------

Replies:

Posted By: rudydapimp
Date Posted: February 01, 2007 at 5:31 PM

you have a second starter wire. prob can use 2nd ignition output from R/S to power it as well. No second ignition that Ive seen in that car. it is BLACK / YELLOW.

Posted By: grizeg
Date Posted: February 02, 2007 at 5:31 PM

do you know which wire goes to which?

The wires coming off the key cylinder are this
BLACK/ green
BLACK / YELLOW
BLACK/ white
WHITE/ red
blue

My remote start harness is this
purple - (+) starter output to starter (starter side)
green - starter input from ignition (key side)
red - (+) high current 12v input
orange - (+) output to accessory curcuit
pink - (+) output to primary ignition circuit
red - (+) high current 12v input
pink/white - (+) output to second ignition circuit
RED / white - (+) high current 12v input

-------------

Posted By: grizeg
Date Posted: February 03, 2007 at 11:29 AM

ok, also i have tried the single wire system, and it is unlocking, but not locking... what is going on with that?
https://www.the12volt.com/doorlocks/page2.asp#n1

-------------