remote starter, bypass, 2005 Honda CRV

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=89932
Printed Date: May 10, 2025 at 5:13 PM

Topic: remote starter, bypass, 2005 Honda CRV

Posted By: marka100
Subject: remote starter, bypass, 2005 Honda CRV
Date Posted: January 09, 2007 at 10:53 AM

I have a 2005 Honda CR-V SE that I have installed a remote starter that I purchased from Asian Wolf (SCYTEC MDL), but have to install an Immobilizer Bypass Module so that the ECU will get the key code and allow the vehicle to start.

I found the Immobilizer connector on the ignition switch, it has seven pins and I need to know the function that each wire controls in order to hook up the Directed 556H Immoblizer Bypass Module.

The Wire colors are as follows: 1. White with Red Stripe, 2. Black with Yellow Stripe, 3. Blue with Orange Stripe, 4. Green with orange Stripe, 5. Grey, 6. White, 7. Brown with Yellow Stripe. If anyone has a wiring diagram for this ignition or knows the functions of these wires, I would greatly appriciate the help. I can be E-mailed direct at: marka100@yahoo.com.

Thanks

MarkA

-------------
marka100

Replies:

Posted By: redpeppers
Date Posted: January 09, 2007 at 11:29 AM

do you not have the install instructions for the bypass module. It has a diagram for the colors at the imobb. harness. Let me know if you do not have the instuctions.

-------------
Where theres is a wire there's a way.

Posted By: KarTuneMan
Date Posted: January 09, 2007 at 12:39 PM

Data. White

Ign. Yellow/blk.

Ground BRN / YELLOW

-------------

Posted By: marka100
Date Posted: February 02, 2007 at 10:55 AM

I purchased a Galaxy 2000RS-MDL from Asian Wolf to put in my wife's 2005 Honda CRV, After the installation I found out this vehicle requires an Immobilizer Bypass Module, so I called Asian Wolf and purchased a Directed Electronics 556H too.

My question is, that the Immobilizer Bypass call out in the installation sheet that its Blue/White needs to be connected to the remote starter, but dosen't specify where! If you know where, please let me know...

Thanks

MarkA

-------------
marka100

Posted By: rabenoja
Date Posted: February 02, 2007 at 7:21 PM

I am not familiar with your remote start system but, the blue/white needs to be hooked up to a ground while running wire from your RS.

-------------

Posted By: jjwallace17
Date Posted: February 03, 2007 at 1:17 PM

Should be the brown wire from the remote starter (just installed one in an Accord)