2007 civic 2 door, micu
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90047
Printed Date: May 17, 2024 at 9:46 AM
Topic: 2007 civic 2 door, micu
Posted By: hanhpham2k
Subject: 2007 civic 2 door, micu
Date Posted: February 04, 2007 at 2:26 PM
please i need help . i can't find The MICU (Multiplex Integrated Control Unit) is part of the fuse/relay box under the driver side dash. It has two plugs on the back of the fuse/relay box. there are to many plugs on the back fuse box..thank you
Replies:
Posted By: lsondubz
Date Posted: February 04, 2007 at 2:39 PM
Well you can look for a 34 pin plug or just look at the plugs until you find the one that has the right colored wires you are looking for, also directechs lists the wires should be in the driver kick as well so you might not have to go to the MICU...
Posted By: hanhpham2k
Date Posted: February 04, 2007 at 4:16 PM
there is 2 red wire in the plug for the 42 pin plug for the parking light . which red wire should i use..thanks
Posted By: captainzab
Date Posted: February 04, 2007 at 4:24 PM
You will have to test your parking light wire with your multimeter to see.
-------------
Note: You Always Dont Get What You Pay For.
Posted By: hanhpham2k
Date Posted: February 04, 2007 at 5:08 PM
i did but it only tested at 3 volts , is that ok
Posted By: drampersad
Date Posted: February 04, 2007 at 5:11 PM
i got the same answer 3 volts use it ------------- happy
Posted By: KarTuneMan
Date Posted: February 04, 2007 at 5:14 PM
Use the gray NEG(-) parking light wire.....it's at the column. There are a couple of "red ones" get the wrong one...poof there goes your guage cluster. They test the same....so be careful.
-------------
Posted By: hanhpham2k
Date Posted: February 04, 2007 at 5:41 PM
there too many green wires for the trunk release ,can you tell me which pin is it ...thanks
Posted By: captainzab
Date Posted: February 04, 2007 at 6:11 PM
Test the wire,
usually alittle thicker than the rest
if you cant find it there, you can find it running to the rear.
-------------
Note: You Always Dont Get What You Pay For.
Posted By: hanhpham2k
Date Posted: February 04, 2007 at 6:53 PM
how do you test it...thanks
Posted By: hanhpham2k
Date Posted: February 04, 2007 at 8:35 PM
please help me , i have a clifford rs3.5 alarm . i need to know there is a wire saids h1/6 blue wire on the installation , where do i hook this wire to in the car ,. and also i can remote start the car but it won't run and keep on restarting again and again ...please help me ...thank you
Posted By: KarTuneMan
Date Posted: February 04, 2007 at 10:39 PM
Use your multi-meter.....pierce the wire, then hit the trunk release on the factory remote....the wire will pulse POS(+) Did you get your bypass module, like the guys said back a couple posts??? The blue wire your trying to find out what to do with is the ground while running. It's used to "turn on" the module, so your car will start. -------------
|