2007 chrysler aspen remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90071
Printed Date: May 21, 2024 at 1:01 PM

Topic: 2007 chrysler aspen remote start

Posted By: ziadmoh
Subject: 2007 chrysler aspen remote start
Date Posted: February 04, 2007 at 8:57 PM

Does anyone has a wiring diagram for this truck?
I used CHDL7-PK2, it worked fine except when you shut the remote start down, the truck stays running!
Help please.

Replies:

Posted By: JWorm
Date Posted: February 04, 2007 at 11:15 PM

Do you have access to directechs.com? I recently asked for a wiring diagram of that truck there and a wiring diagram from Astroflex was posted. Here are the basics:

Battery RED / gray
Ignition Pink/Gray
Starter PURPLE / brown thru 200 ohm resistor to ground
Accessory same purple brown thru a 590 ohm resistor to ground

Brake WHITE/ tan
Parking lights (+) pink/red drivers kick panel
Parking lights (-) pink/red 1.1k ohms

Lock lt. blue/orange 330 ohms in door
UnLock lt. blue/orange 100 ohms in door

I helped another installer do an Aspen last week, so I'm pretty familar with the truck. We used 2 relays for the PURPLE / brown MUX wire and a PKU-CH2 for the key bypass.

Posted By: green6767
Date Posted: February 05, 2007 at 7:41 AM

its very similar to the new rams that dont have the starter wire. You can see my post on the 07 Ram with the mux wiring. Wire it up like that with the appropriate resistor values for the ASPEN and you should be fine. Done a couple aswell, and sounds like JWorm is quite familiar also. So with that combo, should be able to get ya going.

-------------
Shaun, we are the same height, that is neat!

12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.