02 grand cherokee parking lights?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90328
Printed Date: May 04, 2025 at 2:45 AM
Topic: 02 grand cherokee parking lights?
Posted By: 02jeepwj
Subject: 02 grand cherokee parking lights?
Date Posted: February 11, 2007 at 12:33 AM
Hello, How do I get the parking lights to work with my remote starter on my 2002 Jeep Grand Cherokee? I connected the wire from the remote starter to the paring light wire at the switch but it does not work. What do I need to do? Resistor?
Replies:
Posted By: rudydapimp
Date Posted: February 11, 2007 at 4:28 AM
Im assuming that you used the negative parking light wire (yellow at the switch) it is a neg trigger through a 1300 ohm resistor. relay isolate from the switch. From directechs
Posted By: Twelvoltz
Date Posted: February 11, 2007 at 8:41 AM
If I remember correctly you can also just use the hazard light trigger without the need for resistors and isolation from the switch. Dark blue/Pink at the switch, straight negative.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: johnmax
Date Posted: February 11, 2007 at 9:19 AM
On those there is a parking light relay behind the dash. Its the bottom relay in a group of relays right there when you pull off the dash panel. It will click when you turn the pk lights on. Just pull the relay, and stick your negative parking light output wire in the top left pin of the relay receptacle. Then cram the relay back in. Done. No resistor needed.
Posted By: 02jeepwj
Date Posted: February 11, 2007 at 9:35 AM
thanks john great advice!
|