1996 mercury villager wire diagrame
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90633
Printed Date: May 12, 2025 at 1:49 PM
Topic: 1996 mercury villager wire diagrame
Posted By: big j.v.
Subject: 1996 mercury villager wire diagrame
Date Posted: February 18, 2007 at 10:56 PM
I want to install a remot start/keyless entry/alarm in my minivan but I cant find the diagrame that I need to know what wriers to hook it up to. Can someone help me out here?
-------------
Experiance is learning form your mistakes(and not making them again!!!!)
Replies:
Posted By: Twelvoltz
Date Posted: February 18, 2007 at 11:01 PM
DEI Lists:
DIRECTWIRE™ WIRING INFORMATION - MERCURY / VILLAGER / 1996 / Remote Start
[PRINT THIS PAGE]
12volts WHITE/ purple + ignition harness
Starter red + ignition harness
Second Starter WHITE/ blue + ignition harness
Ignition brown + ignition harness
Second Ignition RED / green + ignition harness
Third Ignition
Accessory WHITE/ green + ignition harness
Second Accessory
Keysense
Power Lock GREEN / WHITE - left kick or console
Power Unlock GREEN/ orange - left kick or console
Lock Motor GREEN/ YELLOW drivers kick panel
Unlock Motor WHITE/ green drivers kick panel
Parking Lights+ pnk/blu or pnk/wht left kick
Parking Lights- ORANGE / black headlight switch
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger RED / white - left kick or
Notes: Grounded at rest thru dash ind. - use diode to isolate. Also look for RED / black in unplugged two pin connector in center console. Should also cover rear hatch. There is also a blue (-) wire in the center console that catches all doors on keyless models.
Dome Supervision
Trunk/Hatch Pin lt BROWN / white - left kick
Notes: Grounded at rest thru dash ind. - use diode to isolate. Also look for RED / black in unplugged two pin connector in center console. Should also cover rear hatch. There is also a blue (-) wire in the center console that catches all doors on keyless models.
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm red - drivers kick or SECU
Notes: The Smart Entrance Control Unit is behind the center console.
Factory Alarm Disarm RED / black - drivers kick or SECU
Notes: The Smart Entrance Control Unit is behind the center console.
Disarm No Unlock
Tachometer green ac ign. module on engine
Wait to start
Brake Wire yellow/black + brake pedal switch
Parking Brake
Horn Trigger black - steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
Smart Starter Kill Relays: Not Available
warning
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: big j.v.
Date Posted: February 19, 2007 at 7:23 PM
Do the second igniton and second starter wires need to be connected to make a remote starting system work on ths van?
-------------
Experiance is learning form your mistakes(and not making them again!!!!)
Posted By: jim hunter
Date Posted: February 19, 2007 at 8:59 PM
yes they do, its essentially a nissan van and all nissans have a 2nd starter wire ( some cold start module or so ive been told)
and without 2nd ignition powered up car will not start and may throw trouble codes
so you will have to add a relay fro the 2nd starter wire, the 2nd igniton is onboard in the module
|