dei 508d

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=9079
Printed Date: May 19, 2024 at 12:24 AM

Topic: dei 508d

Posted By: Parkdaddy02
Subject: dei 508d
Date Posted: February 04, 2003 at 9:49 PM

I was wondering where would the best place be to mount a dei 508d motion sensor. It is going into a 1996 s-10 ext. cab. I also have the glass break sensor and i was wondering where the best place for the microphone would be.

-------------
Thanks,

Eric

Replies:

Posted By: BNLUIS
Date Posted: February 05, 2003 at 1:57 PM

Mount the 508D in the middle of the car just below radio under the carpet and The glass sensor will probably fit right above the sterring wheel. But then again you can always look for other spots. Just make sure not to mount the 508d behind metal, it will go trought almost anything except metal.

Good Luck.

Luis
Sound Waves

Posted By: Parkdaddy02
Date Posted: February 05, 2003 at 9:38 PM

Also which wires do i hook the 508d up to, I know where the constant and ground go to but where do the first and second stage outputs go to?

-------------
Thanks,

Eric

Posted By: AlarmTech
Date Posted: February 07, 2003 at 1:24 AM

i would recommed using the GWA wire for the ground, a fused 12v source for the 12v and then (assuming you also have a DEI alarm) tap into the shock sensor wires. green to green, blue to blue.

Or, newer DEI models have a multiplexed wire, that you can simply join the 2 508D green and blue wires together and then connect to the single multiplex wire.

the glass sensor mic should be in open air, meaning the diaphram (face) of the mic should be unobstructed. You could neatly mount it to a dash panel like an LED.

-------------
Viper Equipped