2006 mazda 3 factory alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90818
Printed Date: May 15, 2025 at 2:49 PM

Topic: 2006 mazda 3 factory alarm

Posted By: 05gt
Subject: 2006 mazda 3 factory alarm
Date Posted: February 22, 2007 at 1:45 PM

I am wondering if there is a way you can add some sort of a shock sensor or motion sensor to the factory alarm of this vehicle, and how would I go about wiring it

also the customer would like to put in a L.E.D in the vehicle, which turns on when the factory remote lock button is pressed and then goes off when the unlock button is pressed, and again how would I go about wiring it

thanks in advance, mike

Replies:

Posted By: 05gt
Date Posted: February 28, 2007 at 4:26 PM

anyone??

Posted By: 05gt
Date Posted: March 02, 2007 at 3:31 PM

please if anyone has any info that would be appreciated

thanks mike

Posted By: Twelvoltz
Date Posted: March 02, 2007 at 3:48 PM

You could add a shock sensor and diode it in to a negative trigger like the door trigger. You would also want to wire up a relay that turns the shock sensor off when the ignition is on so it does not light up the door ajar indicator as they are driving down the street.

As to the LED, you would have to put in an LED that turns on when the ignition is off unless you can locate an output that is active only when armed (which I do not believe that system has).

-------------
Installer, IT support, and FFL. I need less hobbies.

Print Page | Close Window