1996 dodge caravan, remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90866
Printed Date: May 21, 2024 at 8:38 AM

Topic: 1996 dodge caravan, remote start

Posted By: jihadmatar
Subject: 1996 dodge caravan, remote start
Date Posted: February 23, 2007 at 11:24 AM

hello guys,

i am installing a remote starter on a 96 dodge caravan tomorrow . i know that i need to unlock the doors(through a resistor) in order to start it up.

i want to start it up with doors locked so i have to trick it. please check for me if this is the right way.

my unit, XS-900S has on board relays for door locks.

so here it goes:

a wire goes from lock wire to pin 30 on relay(why is it the lock and not unlock?)

85 on relay get tied to starter/crank wire on unit

87 goes to ground.

the security bypass wire(-) from unit goes to pin 86.

is this correct. shall i just stick to unlocking the car and starting it up(disarm security if it has it)? please advise.

PS: xs-900s has a wire for security bypass and a wire to provide - for rellay kill.

no wire to send ground when remote start.

thanks for the help in advance.

jay.

Replies:

Posted By: KarTuneMan
Date Posted: February 23, 2007 at 11:53 AM

You don't need to unlock the doors before R/S

If your unit has built in door lock relays, you should have 6 wires from the unit.

2 should be labled N.O. These will go to ground

2 should be labled N.C. You will not use these.

2 will be labled common. These are the wires that go to wht/lt grn. at the bcm. Put your resitors in line at the end or in the middle of these wires.

-------------

Posted By: jihadmatar
Date Posted: February 23, 2007 at 12:15 PM

thanks my friend.

you are awesome.

wish me luck with the audi tomorrow too.

thanks, jay