Print Page | Close Window

remote start in mazda 6 2004

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90876
Printed Date: May 09, 2025 at 8:17 AM


Topic: remote start in mazda 6 2004

Posted By: baldur
Subject: remote start in mazda 6 2004
Date Posted: February 23, 2007 at 1:19 PM

HI i'm having a bit of a problem to install a Thor Professional Alarm system CF425 in my Mazda 6 4cyl 2004.

Here is the troble part : I cant find the charging light indicator  any where in the car looked everywere seems like i always get the oil light.  and if i conect the sence wire of the remote start to that  the car wont start long enogh only 1 or 2 sec !!!!!

does anyone now were i can find that ?? it is not in the lines in the fuse box and not at the altenartor

Please Help getting realy frustraded :(




Replies:

Posted By: KarTuneMan
Date Posted: February 23, 2007 at 2:59 PM

You are looking for a tach wire? to tell the R/S unit when to STOP cranking...correct?

TACH SIGNAL SEE NOTES       
 On the 6 cyl use the wire opposite from the GREEN/ stripe wire at any of the coils on the top of the engine. On the 4 cyl use the wire opposite from the BLACK/ white wire.



-------------



Posted By: baldur
Date Posted: February 23, 2007 at 3:59 PM

Think so don't understantd what tach wire means :) from iceland. But im am bacily  looking for a kine that is negative when the engine is dead and shows 12 volt when on

Thanks for previous reply, and sorry my spelling is not wery good




Posted By: KarTuneMan
Date Posted: February 23, 2007 at 5:28 PM

Ignition...?

try this wire

IGNITION Blue Ignition switch harness  

+ 

The wire you are looking for. What is it going to be used for?



-------------



Posted By: baldur
Date Posted: February 23, 2007 at 5:55 PM

it is sence wire for sucssesful starting that i cant find where to conect !

manual says the wire suld read 3 volts wen off and 12 when engeni is on !

to tell the remote start unit that the start has been sucseccful !




Posted By: KarTuneMan
Date Posted: February 24, 2007 at 12:03 PM
Anyone else got any thoughts on this young man's issue?

-------------



Posted By: baldur
Date Posted: February 24, 2007 at 12:47 PM
I ordered another system not THOR! There is something wrong with this junk !

Thanks for replying


Print Page | Close Window