Print Page | Close Window

01 explorer and 561t

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90919
Printed Date: May 10, 2025 at 2:48 PM


Topic: 01 explorer and 561t

Posted By: rnemtb
Subject: 01 explorer and 561t
Date Posted: February 24, 2007 at 11:39 AM

my problems is 561 t installed operates fine except when remote started factory remotes will not unlock/lock doors.all wires hooked corectly.is this a programming issue? installed in 2001 ford explorer.

-------------
rnemtb



Replies:

Posted By: lsondubz
Date Posted: February 24, 2007 at 11:41 AM
Factory remotes will not work when the car is running/ignition is on...Its normal for 90% of cars...



Posted By: captainzab
Date Posted: February 24, 2007 at 12:00 PM
https://www.the12volt.com/installbay/forum_posts.asp?tid=52391&KW=f150

You can go to the keyless entry module find the black and pink wire test to make sure its ignition Then you can either cut it into or build a relay to interupt it when the truck is remote started.If you are using a dei product there is a yellow wire that is on the main harness it will only put out ignition when the key is on. You can cut the black and pink wire intoand hook this yellow wire up to the keyless side.

Seeing as though its a ford, it might be the same.
Going to see if that works in a few days, for a customer that wants remote start on his facotry remote (03 F150 though)



Has anyone out there interruput that BLACK/ pink wire? if so, does it affect the car in anyway? Also, does it even work?


-------------
Note: You Always Dont Get What You Pay For.




Print Page | Close Window