hyundai elantra 2005 ignition 2
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90942
Printed Date: May 03, 2024 at 12:22 PM
Topic: hyundai elantra 2005 ignition 2
Posted By: mark shook
Subject: hyundai elantra 2005 ignition 2
Date Posted: February 24, 2007 at 9:20 PM
I am installing a alarm and the instructions say I need to connect one of the alarm wires to my Ignition 2 wire on my car. I've seen many Hyundai Elantra wiring diagrams and none of them show anything for Ignition 2. There are no spare wires going to my ignition that it could be, all of them I have identified. What would I use instead?
-------------
Jimbo
Replies:
Posted By: mikvot
Date Posted: February 24, 2007 at 9:25 PM
You dont always have to hook up an ignition 2, the alarm companies just give you that wire as an option, for the cars that do have two ignition wires. On your car, you do not need it.
-------------
Posted By: mark shook
Date Posted: February 25, 2007 at 11:39 AM
Thanks! I was just concerned because in the Installation manual (Prestige Platinum APS 786t) it doesn't give you a choice. Now on the Battery 1 and Battery 2 it says you can just install them on the same constant 12 volt source if you don't have a second constant. would it be good to install it on the ignition 1 wire or just leave it off?
-------------
Jimbo
Posted By: KarTuneMan
Date Posted: February 25, 2007 at 3:19 PM
If you need two inputs 12v for you R/S and the car has to "battery" wires .....spread it out. Why load one constant, when you have 2.
-------------
|