02 caravan r/s trigger
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90979
Printed Date: May 14, 2025 at 1:10 AM
Topic: 02 caravan r/s trigger
Posted By: vwaudifreak
Subject: 02 caravan r/s trigger
Date Posted: February 25, 2007 at 6:56 PM
I just put a R/S system in a 2002 Grand Caravan that uses the OEM remotes to trigger the unit. How should I connect the trigger wire?
Replies:
Posted By: Twelvoltz
Date Posted: February 26, 2007 at 7:15 AM
Make and model of starter would help. With the DEI starters I use they offer a positive activation input. I set the unit to 3 pulse activation so the owner has to press lock 3x to activate the unit.
DEI lists:
Lock Motor tan/white conn. 2, pin 10 @ BCM
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
This wire rests at ground and pulses to +12V when the lock actuator is activated in the lock direction. Use your positive activation input wire to this wire. If your unit does not offer a positive activation input you would have to use a relay to change this pulse from positive to negative.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: vwaudifreak
Date Posted: February 26, 2007 at 9:03 AM
I installed a Ultra Start 1155.
Posted By: Twelvoltz
Date Posted: February 26, 2007 at 1:19 PM
You would use the purple positive start trigger on that model. This wire will activate the unit if it sees 2 positive pulses within 2 seconds.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: vwaudifreak
Date Posted: February 26, 2007 at 1:57 PM
Thanks for your help, that worked. I had to install a wire in the connector, this one didn't have the purple wire.
|