Installation car alarm Golf IV 2002

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=9099
Printed Date: May 28, 2024 at 9:28 PM

Topic: Installation car alarm Golf IV 2002

Posted By: saelbe69
Subject: Installation car alarm Golf IV 2002
Date Posted: February 05, 2003 at 11:10 AM

Hi,

I'd like to know if someone has installed a car alarm in this car. I'd like to know how to roll up and down windows. Thank you.

Replies:

Posted By: BNLUIS
Date Posted: February 05, 2003 at 8:01 PM

most VW's you can usually put Windows up or down by extending the lock or unlock pulse using a channel from the alarm. I'm not Sure in this model. It usally is only recommended to put do windows up only. it will also close the sunroof at the same time.

check all wires

Luis
Sound Waves

Posted By: mpalarm
Date Posted: February 06, 2003 at 12:35 PM

The windows in this vehicle is powered by modules for each of them . I mean, that in every door you have module, which is connected with data-wire to the Body-Control module and ECU of the vehicle. If you want to move the windows up and down, you must connect to the data-wire, which is YELLOW /GREEN, if i remember good, and to send data for each window thrue this wire. How you can imagine this is not immpossible, but very hard. The other way is to install relays in every door for up and down and to connect it to your control module (2 relays in every door and 2 wires from the control module to the relays in every door !) . Better idea is to use the wires for the fabric alarm, how recomends <Bnluis> to you. You can find this wires into the driver`s door. This wires are coming from the inside`s side of the keylock and reach the module in the door, which is part of the window motor. The active signal in this wires is negative (-). You can use the lock wire for hooking up the windows and unlocking wire - for hooking down with longer signal on this wires (abot 15 seconds for full opening or closing). With this wires you can move the roof also. The lockwire was yellow/blue, but i can`t remember the unlock wire. If you want i can send you a diagram for this connection.

If you have need for more info - write me.

MPAlarm

mpalarm@yahoo.com

-------------
MPAlarm

Posted By: saelbe69
Date Posted: February 06, 2003 at 3:06 PM

Thank you very much both two. Mpalarm please, can you send me the diagram for the connection with the fabric alarm. Thank you again.

Posted By: AlarmTech
Date Posted: February 07, 2003 at 1:14 AM

on my 2002 Jetta, (Viper 550ESP) all i did was connect my WNDW UP wire (ch 3) and LOCK wire to the same Yellow/Blue wire. then WNDW DWN wire (ch 4) and UNLOCK wire go to the same YELLOW /GREEN wire.

Requires double unlock pulse to disarm factory alarm and unlock all doors. The drivers door will still unlock first, and then the others about a 1/2 second after.

-------------
Viper Equipped

Posted By: mpalarm
Date Posted: February 07, 2003 at 11:32 AM

send me on my @mail your @mail, because i can`t show you the diagram here, pls

-------------
MPAlarm