94 saab 9000 remote start problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91329
Printed Date: May 12, 2025 at 11:25 AM

Topic: 94 saab 9000 remote start problem

Posted By: gotpiranha
Subject: 94 saab 9000 remote start problem
Date Posted: March 06, 2007 at 12:52 PM

I have the new viper 5900 alarm and remote starter.After I find the tach wire.I did the tach learning with the car running and pressing the valet button until the led stay solid.But after that I tried to start with the remote and the car would only crank nonstop and the car doesnt start at all.Any suggestion

Replies:

Posted By: Twelvoltz
Date Posted: March 06, 2007 at 1:12 PM

Just to make sure you have all of your other connections correct, set the unit to voltage sensing and set your crank time to 1 second. If the vehicle starts and runs you know the problem is with that tach connection and you will need to find another. If it does not start and run your problem is elsewhere.

-------------
Installer, IT support, and FFL. I need less hobbies.

Posted By: gotpiranha
Date Posted: March 06, 2007 at 9:00 PM

How do I go back and set it to sense the voltage?

Posted By: Twelvoltz
Date Posted: March 06, 2007 at 9:36 PM

Keep in mind I only recommend this for troubleshooting. A tachometer connection is the best way to go for that vehicle. Take a look at your installation manual in the programming charts. Options 3-2, 3-5, and 3-6.

-------------
Installer, IT support, and FFL. I need less hobbies.

Posted By: gotpiranha
Date Posted: March 07, 2007 at 12:50 AM

Okay Thanks for the info.Also is there a way I can reset the whole alarm /remote starter back to the factory default setting and start all over?

Posted By: gotpiranha
Date Posted: March 09, 2007 at 12:41 PM

Okay I tried the voltage and it did start acouple time and somtime it doesnt.So I dont know what the problem is now.So I set it back to tach sense and tried the tach learning again and the led never came on.What am I doing wrong here?

Print Page | Close Window