2nd ign wire 2001 chevy truck
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91475
Printed Date: July 17, 2025 at 8:25 AM
Topic: 2nd ign wire 2001 chevy truck
Posted By: garedora
Subject: 2nd ign wire 2001 chevy truck
Date Posted: March 09, 2007 at 3:45 PM
On the 2nd ign wire do you splice the 2nd ign alarm wire into this wire or do you cut the ign wire and connect the + side to the alarm 2nd ign wire.
Replies:
Posted By: KarTuneMan
Date Posted: March 09, 2007 at 4:46 PM
Just connect them, no need to cut it. strip it and solder it.
-------------
Posted By: garedora
Date Posted: March 09, 2007 at 7:14 PM
I have hooked up the 2nd ign wire and still have the same transmission issue. Any other ideas ?
Posted By: Velocity Motors
Date Posted: March 09, 2007 at 8:07 PM
What remote starter are you using ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: garedora
Date Posted: March 09, 2007 at 11:27 PM
this is the link. Sr6000.
https://www.clarion.com/ca/en/products/2006/ungo_security/remote_engine_start/SR6000/ca-en-product-pf_1138706935808.html
Posted By: speed of sound
Date Posted: March 16, 2007 at 5:05 PM
meter the output during remote start and make sure voltage does NOT drop while cranking. If it does use a relay to power up circuit
-------------
Speed of Sound Technologies
230 pershing Dr
Ansonia, CT 06401
203-954-0066
Posted By: iskidoo
Date Posted: March 18, 2007 at 3:36 PM
Did you already drive it with the transmission booted improperly? You may have damaged it. Hooking the wire up now won't undamage it. Hopefully the transmission didn't go on you.
-------------
Steve G
|