Print Page | Close Window

model 555l wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91516
Printed Date: May 21, 2024 at 7:20 AM


Topic: model 555l wire

Posted By: LooneyG
Subject: model 555l wire
Date Posted: March 10, 2007 at 5:49 PM

Question for you guys I've got a DEI Model 555L and was wondering if anyone knew anything about a thick Pink/White Wire that is located at the 2-Pin Power Harness.

Here is what the 555L says on the bottom:

2-pin power harness

Red           (+) Input   12V Constant
Pink/White    (+) Output Ignition 2

7-pin primary harness

Pink          (+)   Input   Ignition
Violet        (-)   Input   Crank (PLII Mode)
Blue/Black    (-)   Input   2nd Ignition
Black        (-)   Input   Chassis Ground
BLACK/ White   (-)   Output Bulb Check
Yellow        #87A R-Code (Key Side)
BLACK / YELLOW #30   R-Code (BCM Side)

I'm installing this in a 2000 Grand Am so any info would be appreciated on what needs to be used and where it goes and what doesn't need to be used. Thanks Everyone !!!!!



Replies:

Posted By: JWorm
Date Posted: March 10, 2007 at 6:09 PM
Wow... you have a really really old 555L. They had that 2-pin harness back on the older units back before it was common for remote starts to have a 2nd ignition output. More than likely you won't use the pink/whte on the 555L. You will just use the 2nd ignition output of the remote start to power the 2nd ignition in the car. I believe you still have to connect that red of the 555L to a constant 12v source.




Posted By: LooneyG
Date Posted: March 10, 2007 at 6:27 PM
Thanks for your reply I figured it was a older 555L especially since it came out of the spare Wiring Box posted_image





Print Page | Close Window