01 impala, pyle pwd250
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91536
Printed Date: May 06, 2024 at 11:51 AM
Topic: 01 impala, pyle pwd250
Posted By: alex79
Subject: 01 impala, pyle pwd250
Date Posted: February 26, 2007 at 9:15 PM
hey vatos... i have cuestion about impala 2001 3.8 i need wiring diagrams for lock doors,dome,trunk, if need parking ligths relay..please give tooo my system alarm is pyle pwd205 ok ok..  see yaaaa camaradas....!!!!! have funnn!!!
Replies:
Posted By: KarTuneMan
Date Posted: February 27, 2007 at 8:29 AM
| LOCK | ORANGE / black | Pin-B3 on C2 connector at BCM | - | | | | This single wire doorlock system uses ground to unlock and ground through a 480-ohm resistor to lock. This wire is found at the BCM above the driver's kickpanel. See the DOORLOCK diagram for instructions. |
| | | | | | TRUNK RELEASE | Black or Lt.blue | SEE NOTES | - | | | | BLACK is the ( + ) trunk release relay output and is found at pin-A7 on the pink 16-pin C3 connector. LT.BLUE is the ( - ) trunk release relay input and is found at pin-A2 on the gray 24-pin C2 connector |
|
| PARKLIGHTS | Lt.blue | At light switch harness | - |
And...what the heck is a Vato....sounds degrading? |
-------------
Posted By: alex79
Date Posted: February 28, 2007 at 9:39 PM
the lock and unlock need relay.. or only need resistor to lock in case the relay can u tell how i do the conections .. please..
ohh sorry (vato=boy)the lenguage "cholo"..but i s no bad
Posted By: alex79
Date Posted: March 10, 2007 at 10:47 PM
hi.. i have cuestion:
about how make conections.. trunk tigger.......(-)
door tigger.... (-)
my car is impala 2001 3.8
and my system alarm is pyle pwd250
Posted By: ferretvw
Date Posted: March 10, 2007 at 11:15 PM
Door trigger is in a gray 16 pin plug at the BCM Directechs says the following:
The drivers door trigger wire is blue. Blue/white will catch all other doors. Use both wires and diode isolate each.
The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall.
Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information.
And the trunk trigger is in a gray 24 pin plug at the BCM and directechs says:
CHEVROLET, IMPALA, 2001, Trunk/Hatch Pin
The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall.
Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information.
And just for good measure here is a link to directfax document 1076
https://www.directechs.com/techtips/pdfs/resources/security/directed_techtips/1076.pdf
-------------
2008 Scion xB
Pioneer AVIC-D3
RF 3Sixty.2 sound processor
Stock speakers (for now ;))
Posted By: alex79
Date Posted: March 11, 2007 at 5:04 PM
Door trigger is in a gray 16 pin plug at the BCM Directechs says the following:
The drivers door trigger wire is blue. Blue/white will catch all other doors. Use both wires and diode isolate each.
i have link ,Door trigger is in a gray 16 pin with diode in same conection, together The drivers door trigger wire blue. Blue/white to other doors?
the bcm have two gray and one pink.... is in the middle or in ther side ?
https://www.directwholesale.net/diagrams/diagram.asp?ModelID=17070&MakeID=54&link=SHELBY
what color is for ,And the trunk trigger is in a gray 24 pin plug
the bcm have two gray and one pink.... is in the middle or in ther side ?
same for Door trigger is in a gray 16 pin ,color???
thanks...for u help...
do have menphis 12 mojo?? for sale?
|