dome light supervision output

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91613
Printed Date: May 12, 2024 at 10:13 AM

Topic: dome light supervision output

Posted By: ren_l
Subject: dome light supervision output
Date Posted: March 12, 2007 at 6:35 PM

i have a 91 acura integra with nothing power "windows -doors" .i want to install my Radiostar generation two way alarm but as far as i know i only have one wire to the dome light and i dont know weather i should connect the negative door trigger the positive door trigger or the dome light supervision cord to this wire.

-------------
jjj

Replies:

Posted By: KarTuneMan
Date Posted: March 12, 2007 at 6:41 PM

You can use the dome wire without any problems. For both door trigger and dome supervision.

-------------

Posted By: ren_l
Date Posted: March 12, 2007 at 6:48 PM

so what you are saying is to connect all 3 wires to the dome wire?what exacly dose that dome supervision wire do?

I wont drink and drive its bad

-------------
jjj

Posted By: KarTuneMan
Date Posted: March 12, 2007 at 7:04 PM

your door trigger is negative so attach your neg door trigger INPUT to the negative dome wire. Also attach the NEG(-) domelight supervision wire to this one as well. It turns the dome light on when you disarm. you can use this wire.

DOORPIN

GREEN/ red

In driver's kickpanel

-------------

Posted By: ren_l
Date Posted: March 12, 2007 at 7:10 PM

thanks a million my head was gonna explode .lots of good karma going ur way

-------------
jjj

Posted By: Twelvoltz
Date Posted: March 12, 2007 at 7:48 PM

You do not need to connect the positive door trigger at all. This wire allows the system to fit more than one type of vehicle. Your vehicle uses negative trigger so just use that one and cap off the positive trigger wire.

You may need a relay for the dome light supervision to operate. I know the DEI systems I deal with do not have enough of an output to run the light bulb in most vehicles from that era. Does your Radiostar unit list an internal relay for supervision or does it just list a 200ma output? If it has the internal relay then you will not need anything extra, if it does not you will probably need a relay.

-------------
Installer, IT support, and FFL. I need less hobbies.

Posted By: KarTuneMan
Date Posted: March 12, 2007 at 9:42 PM

ren_l] wrote:

hanks a million my head was gonna explode .lots of good karma going ur way

Read my sig..... I need the good karma. Thanks

-------------