Im trying to install the Python 1500 ESPsystem into a vehicle with a Viper 5000 already installed in it. Using channel 3 to operate the remote starter from the Python. Im trying to use the Python as a stand alone remote starter, however Im having trouble with the programming of the Viper.
Whenever I press the buttons to operate channel 3, the car starts but then suddenly dies a couple seconds later. So I go into shutdown diagnostics from the Python system and it says giving me 4 blinks from the LED light meaning: Transmitter shutton (Or optional pushbutton).
I have a feeling I dont have the settings correct on the Viper system. By any chance does anyone know what menu 3 option 5 should be? Thanks in advance.
Yep, and yep.
I strongly feel like it has to do with the settings from the Viper. Oh, so sorry I mentioned that it was the 5000 model, but its actually the 3000 model. I just need to know what setting menu 3 option 5 should be at.
mobilecustoms wrote:
validity and set the r/s for 1 activation input or remote start report
Last night I actually tried all the settings on the Viper, and the remote start still shutdown after starting. Checked diagnostics on the r/s and it blinked 4 times. So I tested the ch.3 output wire on the Viper, and it was throwing a non-stop ground whenever ch.3 was activated. Is there anything I should change with menu 3 option 6? Oh and the r/s is already programmed to 1 activation input.
kgerry wrote:
what type of vehicle is it? what bypass module was used?
Its a 2001 Galant. It has nothing to do with the bypass but if you must know its the 555U.
set it for remote start report setting. it should take care of it then.
-------------
Or was it the 556U. Its one of those I cant remember off the top of my head, but the problem Im having has nothing to do with the bypass because when I touch the activation input wire from the r/s, the vehicle starts up with no problem. Its when the Viper is being used to activate the r/s, Im having problems with.