Print Page | Close Window

03 mazda speed protege

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91922
Printed Date: May 16, 2024 at 6:24 PM


Topic: 03 mazda speed protege

Posted By: timaay
Subject: 03 mazda speed protege
Date Posted: March 20, 2007 at 9:10 PM

Hey guys,

I have done all of the research I could, but have different sources telling me different things so I have a few questions.

1. Is there any wiring differences between a standard Protege and the Speed?

2. Is a transponder bypass required for this vehicle, if so can you recommend a good no key required model?

3. Lock and Unlock are the same wire? Need 1k resistor through neg trigger to activate?

4. I am installing a new compustar pro series and have not yet installed one, though I have done many of the standard ones, but anyone know of any major differences I should prepare for?

Thanks in advance



Replies:

Posted By: profuse007
Date Posted: March 21, 2007 at 12:12 AM
Remote Start          
     WIRE          COLOR          POLARITY          LOCATION     
     Battery          BLACK          (+)          IGNITION SWITCH HARNESS     
     Ignition 1          BLUE          (+)          IGNITION SWITCH HARNESS     
     Ignition 2          BLACK/ RED          (+)          IGNITION SWITCH HARNESS     
     Accessory 1          BLACK/ WHITE          (+)          IGNITION SWITCH HARNESS     
     Starter 1          BLACK/ BLUE          (+)          IGNITION SWITCH HARNESS     
     Key Sense          WHITE          (+)          IGNITION SWITCH HARNESS     
     Neutral Safety          BLACK/ BLUE          (-)          AT MODULE UNDER CENTER CONSOLE - PIN #25     
     Tachometer          VIOLET/WHITE          (AC)          AT DIAGNOSTIC CONNECTOR     
DIAGNOSTIC CONNECTOR IS LOCATED IN THE DRIVER'S SIDE REAR OF ENGINE COMPARTMENT     
     Speed Sense          GREEN/ RED          (AC)          IN HARNESS BEHIND INSTUMENT CLUSTER     
     Parking Lights          LIGHT GREEN/ BLACK          (+)          AT BLACK CONNECTOR NEAR STEERING COLUMN     
     Brake Lights          GREEN/ YELLOW          (+)          AT SWITCH ABOVE BRAKE PEDAL     
     Reverse Lights          RED / YELLOW          (+)          IN DRIVER'S KICK PANEL     
     Horn          BLACK/ RED          (-)          IN STEERING COLUMN HARNESS

     Doorlocks     
     WIRE          COLOR          POLARITY          LOCATION     
     Power Unlock          LIGHT GREEN/ RED          (-)          AT MODULE TO THE LEFT OF THE BRAKE     
STRAIGHT GROUND WILL UNLOCK THE DOORS     
     PowerLock          LIGHT GREEN/ RED          (-)          AT MODULE TO THE LEFT OF THE BRAKE     
GROUND THROUGH A 1K OHM RESISTOR TO LOCK


All Door Trigger          BLACK/ BLUE          (-)          IN DRIVER'S KICK PANEL     
     Trunk Trigger          BLUE          (-)          AT LIGHT IN TRUNK OR HARNESS GOING INTO TRUNK     
     Parking Lights          LIGHT GREEN/ BLACK          (+)          AT BLACK CONNECTOR NEAR STEERING COLUMN

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).




Posted By: timaay
Date Posted: March 21, 2007 at 7:15 AM
Thanks, but is there a bypass module required?




Posted By: Twelvoltz
Date Posted: March 21, 2007 at 11:44 AM
No transponder bypass is required on an 03 Mazda Protege, the speed is the same car with a better drive train.

-------------
Installer, IT support, and FFL. I need less hobbies.





Print Page | Close Window