2000 yukon denali, factory disarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=92010
Printed Date: May 17, 2024 at 6:12 AM
Topic: 2000 yukon denali, factory disarm
Posted By: Anthnynixon
Subject: 2000 yukon denali, factory disarm
Date Posted: March 22, 2007 at 9:34 PM
Trying to locate the factory disarm wire in a 2000 GMC Denali. Owner says every once and a while the horn will start honking after unlocking. Where is the factory disarm wire for this vehicle
Thanks
Replies:
Posted By: rudydapimp
Date Posted: March 22, 2007 at 11:35 PM
lt. green - pin B3, purple plug at BCM
Posted By: KarTuneMan
Date Posted: March 23, 2007 at 8:00 AM
The factory alarm will disarm when the ignition is energized by the remote start.
-------------
Posted By: Anthnynixon
Date Posted: March 23, 2007 at 11:01 PM
there is no purple plug at the bcm, also it only does it when unlocking, remote starting is fine, no alarm goes off
Posted By: mikvot
Date Posted: March 23, 2007 at 11:32 PM
At the bcm, under the steering column......plug to the far right.
-------------
Posted By: Anthnynixon
Date Posted: April 15, 2007 at 9:50 PM
there is no bcm under the steering column. It is located in the middle center console but there is not purple plug. I tested most of the wires and none of them trigger negtive when I unlock the doors? Also there is no disarm wire in the kick panel. Do anyone know where to locate this wire, or a bypass that will use the databus to factory disarm?
Posted By: b2reptile
Date Posted: April 17, 2007 at 10:25 AM
You might try looking in the drivers door. Look for light green wire at the door lock key cylinder. It should test negative when turning the key to unlock in the drivers door.
Posted By: tonyberg
Date Posted: April 17, 2007 at 11:45 AM
a 2000 denali is like a 2000 escalade wire up a relay to pulse 12v on to the brown 2nd Acc wire at the steering columun and you are done.
|