Print Page | Close Window

529t causes motor to run continuously

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=93467
Printed Date: May 04, 2024 at 12:10 AM


Topic: 529t causes motor to run continuously

Posted By: supergecko
Subject: 529t causes motor to run continuously
Date Posted: April 29, 2007 at 11:30 PM

I installed a 529T window module so that it closes the sunroof of my 94 Integra when my alarm is armed. However, when I arm my alarm, the sunroof motor runs continuously even after the sunroof is closed. I have the orange wire from the 529T connected to the orange 'ground when armed' wire from my alarm brain. What am I missing here?



Replies:

Posted By: KPierson
Date Posted: April 30, 2007 at 8:05 AM
Did you diode isolate the orange wire going to the 529T from any other wires going to the orange wire of the alarm (like a starter kill relay?)

-------------
Kevin Pierson




Posted By: supergecko
Date Posted: April 30, 2007 at 6:10 PM
I do not have anything else hooked up to the 'ground when armed' output, just the one wire coming from the 529T is connected.




Posted By: KPierson
Date Posted: April 30, 2007 at 9:24 PM
Did you hook the outputs up to the switch wires or the sunroof motor wires?

-------------
Kevin Pierson




Posted By: supergecko
Date Posted: May 01, 2007 at 3:06 AM
I'm pretty sure I hooked them up to the motor wires. Correct me if I'm wrong, but hooking them up to the switch wires wouldn't do anything because the switch would still be left open, which would cause the sunroof to not respond at all.

I hooked the wires up as follows, I have a 94 integra coupe:

529T      Car wiring
blue   -> green yellow motor side
brown -> green yellow switch side

green -> green red motor side
white -> green red switch side





Print Page | Close Window