i need an iom chrysler 7 interface
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=93511
Printed Date: May 16, 2024 at 1:15 AM
Topic: i need an iom chrysler 7 interface
Posted By: jaydavis78
Subject: i need an iom chrysler 7 interface
Date Posted: May 01, 2007 at 1:35 PM
I have been waiting for several months to have a remote start system installed on my 2005 Chrysler 300 Touring. After many sessions we have reached a point where the IOM-Chrysler-7 interface is all that is needed to complete the install. However, I am having no luck finding one. Any suggestions/help would be infinitely appreciated!
Replies:
Posted By: KarTuneMan
Date Posted: May 01, 2007 at 2:57 PM
Sounds like an Astroflex part # to me. Find an Astro dealer. It should cost ya round 60 clams. Astro has a dealer locator on their website. www.astroflex.com-------------
Posted By: JWorm
Date Posted: May 01, 2007 at 4:34 PM
The CHDL7-PK2 is another module that will do the door locks and transponder bypass. If you just need a doorlock interface, then the CHDL7 will work.
Google works...
One result I found:
https://www.autoalarmpro.com/inc/sdetail/3161
Posted By: KarTuneMan
Date Posted: May 01, 2007 at 6:41 PM
66 bucks....I wasn't off by too much....Nice. Google rocks man..  -------------
Posted By: johnmax
Date Posted: May 01, 2007 at 7:39 PM
Good luck getting one of those. Omega owns them all by now...
Posted By: jaydavis78
Date Posted: May 02, 2007 at 12:35 PM
Thanks fellas, i was able to find it!! now i just need them to send it to me.
I appreciate the information!
Posted By: bostonjosh19
Date Posted: June 25, 2007 at 9:41 AM
Did you end up finding the IOM Chrysler 7? If so, where? I still haven't found it. Astro's site only has up to the 6 for what I can see.
Posted By: KarTuneMan
Date Posted: June 25, 2007 at 10:46 AM
bostonjosh19 wrote:
Did you end up finding the IOM Chrysler 7? If so, where? I still haven't found it. Astro's site only has up to the 6 for what I can see.
Astro's web site is sometimes a tad bit slow.... they do make the 7 and it's on the Astrochart. Same functions as the 6, but more applications! -------------
Posted By: dranged
Date Posted: June 26, 2007 at 8:33 PM
i got five of them in today. Having problems programming them. Dont really understand the instructions, put this key in , then take it out, put 2nd key in wait for light to flash, pull out circuit board out of 1st key , re-insert 1st key and turn on to ign. while holding the iom 7 box to the key cylinder. ????? I'm about to blow this 07' Dodge Ram up. seriously. Has anybody programmed and installed one of these yet? really need help on this one.
Posted By: dranged
Date Posted: June 26, 2007 at 8:36 PM
also i forgot, everytime i remote start it, it starts and the starter keeps running.
Posted By: vitrox
Date Posted: June 28, 2007 at 3:25 PM
umm.. get a tach wire and it shouldn't grind the starter. to program the module do exactly like you said. take one key apart but leave the board in it. turn 1st key on, wait till light goes out. Turn 2nd key on (the one thats taken apart), wait till light begins to flash (about 10 seconds). take 2nd key out, pull board on it. reinsert key into ignition without board. Place module next to head of key and turn on. Wait till light come on, goes out, then comes back on solid and goes out. Turn key off, then turn back on with module next to head to check if it starts. if it does, then the module programed properly.
|