1990 nissan 300 zx factory alarm problems
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=94008
Printed Date: April 25, 2024 at 7:28 PM
Topic: 1990 nissan 300 zx factory alarm problems
Posted By: jazzcustom131
Subject: 1990 nissan 300 zx factory alarm problems
Date Posted: May 17, 2007 at 5:52 PM
I have an aftermarket clifford installed on this car, and there is some mis communication between it and the factory alarm. When I activate the clifford, the other alarm goes off and the starter kill engages. Even after it goes off, the starter kill stays engaged, so my car hasn't moved for 3 days. Anyone know how i can get rid of the factory alarm?? I don't know where the brain for it is,
-------------
Greed is for amateurs.
Disorder,chaos,anarchy now THAT is fun!!
Replies:
Posted By: peterubers
Date Posted: May 17, 2007 at 7:00 PM
| FACTORY ALARM DISARM | GRAY/RED (-) | IN DRIVERS KICK PANEL |
I dont' think you can get rid of the factory alarm w/o removing the BECU/mutliplex unit. I would consider resetting the clifford and checking some wiring if you can -- the above wire is the disarm for your factory alarm. I am not sure, but i'm i don't think Nissan's factory alarm includes a factory starter-kill. I think your best bet at this point would be to disconnect the clifford alarm brain and attempt to start your vehicle. If you cannot, look for a SPDT relay connected to the starter wire and reconnect the wires at the 30 and 87a termina ------------- The search function is your friend.
Posted By: burns25
Date Posted: May 18, 2007 at 3:24 PM
The factory alarm brain is under the passenger seat from what I remember. I also seem to remember not being able to find the factory disarm in the driver's kick but it was in the passenger kick. It's been quite a while since I did one of these so it's a bit hazy.
Posted By: jazzcustom131
Date Posted: May 21, 2007 at 10:44 PM
so if I snip that Gray/Redwire, the alarm "goes away", correct?
-------------
Greed is for amateurs.
Disorder,chaos,anarchy now THAT is fun!!
Posted By: tonyberg
Date Posted: May 22, 2007 at 9:19 AM
no...if you ground it, it goes away
Posted By: nobles
Date Posted: May 23, 2007 at 3:57 PM
there is a hood pin switch, play with it a little, then use the key to unlock the pass door, the car will sart (based on something similar I did before)
|